Desa (V)DVF36TCRP(E) Owner's Operation And Installation Manual

www.desatech.com112108-01C 2OFFPILOTONLOHIPILOTE A16AI7TPTH TP THGas ControlKnobFlame AdjustmentKnobPositionIndicatorFigure 56 - Millivolt Control ValveFigure 57 - PilotThermopilePilot BurnerPiezo IgnitorThermocouple6. Wait five (5) minutes to clear out any gas.Then smell for gas, including near the floor.if you smell gas, SToP! Follow “B” in thesafety information, page 28. if you don’tsmell gas, go to the next step.7. Turn knob on gas control counterclockwiseto PiLoT.8. Push in the control knob all the way andhold in. immediately light the pilot bypressing the ignitor button until a flameappears 1 minute after the pilot is lit. Thepilot is located by the main burner. releaseknob and it will pop back up. Pilot shouldremain lit. if it goes out, repeat steps 5through 8.• if knob does not pop out when released,stop and call gas supplier.• if the pilot will not stay lit after several tries,turn gas control knob to oFF and call yourservice technician or gas supplier.9. Turn gas control knob counterclockwiseto “N. Knob can be turned to oNonly if the control knob is popped out.10. Set hi-Lo knob to desired setting.11. Turn on all electric power to the appliance.TO TURN OFF GASTO APPLIANCE1. Turn off the wall switch.2. Turn off all electric power to the applianceif service is to be performed.OPERATING FIREPLACEContinued3. remove control access panel.4. Push in gas control knob slightly and turnclockwise to oFF. Do not force.5. replace control access panel.ELECTRONICFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which must belighted by hand. When lighting the pilot,follow these instructions exactly.B. BeFore LiGhTiNG smell all around theappliance area for gas. Be sure to smell nextto the floor because some gas is heavier thanair and will settle on the floor.WhAT To Do iF YoU SMeLL GAS• Do not try to light any appliance.• Do not touch any electric switch; do notuse any phone in your building.• immediately call your gas supplier froma neighbor’s phone. Follow the gassupplier’s instructions.• if you cannot reach your gas supplier, callthe fire department.C. Use only your hand to push in or turn thegas control knob. Never use tools. if theknob will not push in or turn by hand, don’ttry to repair it, call a qualified service tech-nician or gas supplier. Force or attemptedrepair may result in a fire or explosion.D. Do not use this appliance if any part hasbeen under water. immediately call aqualified service technician to inspect theappliance and to replace any part of thecontrol system and any gas control whichhas been under water.LIGHTINGINSTRUCTIONS1. SToP! read the safety information beforeproceeding.2. Set thermostat to lowest setting (if appli-cable).3. Turn off wall switch.4. open control access panel or louver.