Desa VMH10TPB Owner's Operation And Installation Manual

Also see for EFS10TN: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Operation and installation manual

107032For more information, visit www.desatech.comFor more information, visit www.desatech.com221. Remove log packaging material and discard packaging. Gen-tly place log on burner support (see Figure 44). The log shouldfit flat against top of burner support and log locator tabs fitinto the slots under the log. Do not allow log to contact flame.If flame contacts log, soot will be created.2. Reattach screen by placing the notches in the screen frameover the shoulder screws and pushing down.INSTALLING LOG SET AND SCREENFigure 44 - Installing Log and ScreenLogShoulder ScrewScreenBurner Support withLog Locator TabsINSTALLATIONContinued6. Connect one bare wire end to each terminal (“W” and “R”) ofthe thermostat base (see Figure 43).7. Install the base onto the wall with the provided screws.8. Move the temperature adjustment back and forth to insure thebimetal is free from restrictions.9. Replace the cover onto the base. (Upon installation, the ther-mostat must be allowed to stabilize at room temperature fora minimum of 30 minutes for proper operation).10. Set switch on fireplace to Auto position.11. Set the temperature adjustment to the desired setting. This ther-mostat has been electronically calibrated at the factory. No ad-justment or leveling is necessary.Figure 42 - Back View of Thermostat BaseFeed wires through rectangular slotsWRFigure 43 - Thermostat Base Terminals “W” and “R”Terminal “W”Terminal “R”OPTIONAL WALL SWITCH - GWMS2(Remote-Ready Models Only)WARNING: Do not connect this switch to anyelectrical source! Electrical shock and/or fire hazardwill occur.1. Connect one terminal of 25 ft. wire to bottom contact of switch(see Figure 41, page 21).2. Connect remaining wire terminal to the “TH” terminal on thecontrol valve. Make sure that wire terminals are in the posi-tions on your unit as pictured in Figure 41, page 21. If wiresare not “crossed” the thermostat will not work.3. Route the 25 ft. wire to a convenient location to mount yourwall switch (no outside walls).WARNING: Do not connect the switch to a powersource. Electrical shock and/or fire hazard will occur.WARNING: Read and follow installation instruc-tions. Installation should be done by a qualifiedinstaller familiar with low-voltage wiring procedures.IMPORTANT: The wire may be shortened but must not belengthened.4. Connect one bare wire end to each of the terminals of the pro-vided wall switch.5. Install the wall switch and cover in the wall.INSTALLATIONOptional Wall Mounted Thermostat - GWMT1 [Remote-Ready Models Only] (Cont.)Optional Wall Switch - GWMS2 [Remote-Ready Models Only]Installing Log Set and Screen