Desa VRL24NR Owner's Manual

Also see for CSG3924NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operating & installation manual

Contents

Desa VRL24NR Owner's Manual Manual pdf 32 page image

www.desatech.com 110021-01S32OPTIONAL POSITIONING OF THERMOSTAT SENSING BULBFigure 44 - Adhesive-backed Mounting ClipAdhesive-backedMounting ClipFigure 45 - Locating Thermostat SensingBulb on Masonry FireplaceThermostatSensing BulbThermostatSensing BulbFigure 46 - Locating Thermostat SensingBulb on Factory-built Metal FireplaceAdhesive-backedMountingClipGlass DoorsFigure 47 - Installing Thermostat SensingBulb Behind Glass DoorsThermostatSensing BulbAdhesive-backedMounting ClipFigure 43 - Location of Gas ValveAssembly and Thermostat Sensing BulbGas ValveAssemblyThermostatSensing Bulb RetainingClampCapillaryThermostatSensing BulbDo Not CrimpCapillaryAdhesive-backedMounting ClipFigure 48 - Positioning ThermostatSensing Bulb in the Vertical Positionwith Capillary at the BottomFOR MASONRY AND FACTORY-BUILT METAL FIREPLACEIf your log set cycles to pilot, but the room tem-perature drops to a lower than ideal comfort levelbefore the log set comes back on, you may wantto reposition the thermostat sensing bulb.The thermostat sensing bulb is located nearthe gas valve assembly on the mountingbracket. This location allows the thermostatto keep the room temperature at an idealcomfort level for most fireplace applications.For positioning the thermostat sensing bulbelsewhere, an adhesive-backed mountingclip is available.1. Locate the gas valve assembly and ther-mostat sensing bulb (see Figure 43).2. Gently pull thermostat sensing bulb freefrom the retaining clamp.IMPORTANT: Do not force or bend thethermostat sensing bulb or capillary.3. The thermostat sensing bulb may be locat-ed to the lower right front side of fireplace.Determine location of sensing bulb, butdo not mount sensing bulb until step 4. Ifyou have a masonry fireplace, see Figure45 for location. If you have a factory-builtmetal fireplace, see Figure 46 for location.If your fireplace has glass doors, positionsensing bulb directly behind door gap onright bottom side (see Figure 47).4. The mounting clip must be a minimum of 3"from bottom of fireplace to prevent crimp-ing of capillary. Once you have decidedon a location, clean the area thoroughly.Remove paper backing from adhesive onback of mounting clip. Press clip into newlocation so that the thermostat sensingbulb will be positioned vertically with thecapillary at the bottom (see Figure 48).Slide thermostat sensing bulb into clip.IMPORTANT: Do not crimp capillary.