Desa VV36EN-B Series Owner's Operation And Installation Manual

Also see for V36EN-B SERIES: OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com111253-01F 152. Attach green ground wire from power cord to blower housingusing screw provided (see Figure 25, page 14). Tighten screwssecurely.3. Place the blower against the lower rear wall of the firebox outerwrapper with the exhaust port directed upward. The blower willfit inside the back opening and be held in position against theback wall by the magnets (see Figure 25, page 14).4. Be certain that all wire terminals are securely attached to ter-minals on blower motor and that the screw retaining the greenground wire is tight.5. Mount speed control box to switch bracket by placing the plasticcontrol shaft forward through the opening in the switch bracket(see Figure 26).6. While supporting speed control, secure control shaft with locknut by pushing and turning lock nut with pliers clockwise untilit is tight against front panel. Place control knob provided onshaft.7. Turn on power to duplex outlet if previously turned off per thewarning in column 2, page 14.8. Plug in blower power cord.a. If your firebox is installed as a freestanding unit with anaccessory mantel, determine whether the power cord willexit the left side or the right side of the firebox. Route powercord through exit hole and plug the power cord into a wallreceptacle near the firebox.b. If your firebox installation is recessed and/or pre-wired, plugthe power cord into the duplex outlet provided. Refer to yourfirebox owner’s manual for instructions on wiring the duplexoutlet.CAUtION: Never touch the blower wheel while inoperation.9. Check to make sure that the power cord is completely clear ofthe blower wheel and that there are no other foreign objects inblower wheel. Turn blower on and check for operation. Turnblower off by turning knob fully counterclockwise beforecontinuing.10. Peel off the backing paper and stick the supplied wiring diagramdecal on the firebox bottom approximately 12" in front of theblower (see Figure 27).FIREPLACE INSTALLATIONContinuedFigure 26 - Attaching Speed Control to FireboxSpeed ControlControl ShaftLocknutControl KnobSwitchBracketDuplex Outlet (Locatedunderneath fireboxfloor against lower rightoutside wall)BlowerPlug-InVariableFan SwitchWhiteWhiteBlackGreenOn110/115V.A.C.BlowerMotorBlackBlackBlackOffFigure 27 - Location of Wiring Diagram Decal (Model MayVary From Illustration)Wiring Diagram Decal12" in Front of BlowerModel bKT InstallationNote: When installing the BKT thermostatically-controlled blower,you must first secure the thermal switch bracket to the blower if ithas not already been factory installed.1. Place the green ground wire with ring terminal between thebottom hole on the thermal switch bracket and the top ear holeon the blower assembly. Insert the Phillips screw into all threepieces and tighten securely (see Figure 28).2. Connect wire harness and power cord terminals. Connect theblue jumper wire to the blower motor terminal and the rightside terminal of the thermal switch. Connect the black wire tothe left side of the thermal switch and the white wire to theother remaining blower motor terminal.Note: The power cord outer insulation sleeve may have to bestripped slightly to allow enough wire length to reach and makeall connections. DO NOT trim excessive length away. Just enableenough to make all connections securely.ThermodiscFigure 28 - Blower Model BKTAir Flow DirectionRoute BKT BlowerThrough This AreaMagnetsBlowerLocationSide View Firebox BottomBlackWirePhillipsScrewBlue WireRing Terminalon Green WireWhite WireThermal SwitchThermalSwitchBracketPower CordAir FlowDirectionMagneticStrips