Desa VV36EN-B Series Owner's Operation And Installation Manual

Also see for V36EN-B SERIES: OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com111253-01F 312. Do not use this fireplace to cook food or burn paper or otherobjects.13. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)in this fireplace. Use only the gas type indicated on fireplacenameplate.14. This appliance, when installed, must be electrically groundedin accordance with local codes or, in the absence of localcodes, with the National Electrical Code, ANSI/NFPA 70, orthe Canadian Electrical Code, CSA C22.1.15. Do not use fireplace if any part has been exposed to or underwater. Immediately call a qualified service person to arrangefor replacement of the unit.16. Do not operate fireplace if any log is broken.17. Do not use a blower insert, heat exchanger insert, or other ac-cessory not approved for use with this fireplace.18. Do not operate fireplace with glass door removed, cracked, orbroken.19. Provide adequate clearances around air openings.PRODUCT IDENTIFICATIONSAFETy INFORMATIONContinuedFigure 1 - Victorian Direct-Vent Fireplace withElectronic IgnitionLOCAL CODESInstall and use fireplace with care. Follow all local codes. In theabsence to local codes, use the current National Fuel Gas CodeANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Instal-lation Code (Canada).*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269PRODUCT FEATURESThese are a few facts that can help you understand and enjoy yourdirect-vent fireplace:• The venting system may be routed to the outside of your homein several ways. It may vent through the roof (vertical) or it mayvent to an outside/exterior wall (horizontal). The vent pipe instal-lation is very important to allow for proper operation. You mustfollow the venting instructions very carefully for either verticalor horizontal applications.• This fireplace may be installed in any room of your houseprovided all local codes and these installation instructions arefollowed.• The blower requires electricity if installed and if you plan toinstall the blower at a later date, do not forget to wire the outletat the bottom of the fireplace when framing.• The electronic ignition creates spark to ignite the pilot light. Itdoes not require any matches, batteries or any other sources ofignition to light the pilot.• Each time you turn on your fireplace, you may notice someamount of condensation on the inside of the fireplace glass. Thisis normal and will disappear after 10-20 minutes of operation.• Your direct-vent gas fireplace system (fireplace and venting) is abalanced and sealed gas operating unit. It requires approximately 10-20 minutes of operating time before the flame pattern stabilizes.GlassDoorAssemblyBlower Switch(OptionalInstallation)ControlValveLog SetLavaRockGlowingEmbersUpper LouverPanelLowerLouverPanelFlue CollarNailingFlangeON/OFF/REMOTESwitch (OptionalInstallation) GrateAssembly