Dynex DX-LCD22-09 User Manual

Also see for DX-LCD22-09: Service manual Guía del usuario Guide de l'utilisateur

20 Assembling the stand and removing the stand columnAdjusting advanced VGA settingsTo change the advanced VGA settings:1 Press MENU. The Picture menu opens.2 Press or to select Setup, then press . The Setup menuopens.3 Press or to highlight Advanced, then press or ENTER.The Advanced sub-menu opens.4 Press or to highlight an option, then press or to adjustthe option. Available options include:5 Press MENU to return to the previous menu or EXIT to resumenormal viewing.Assembling the stand andremoving the stand columnYou must install your TV into the stand in order for it to stand upright ona cabinet or other flat surface. If you intend to mount your TV on a wallor other vertical surface, you must remove the stand column.Cautions:Read these instructions thoroughly before attempting this installation.Make sure that you handle your TV very carefully when attemptingassembly or removal of the stand. If you are not sure of your ability todo this, or of your ability to use the tools necessary to complete this job,refer to a professional installer or service personnel. The manufactureris not responsible for any damages or injuries that occur due tomishandling or improper assembly.When using a table or bench as an aid to assembly, make sure that youput down a soft cushion or covering to prevent accidental scratching ordamage to your TV’s finish.The speaker is not intended to support the weight of your TV. Do not moveor handle your TV by the speaker. This can cause damage to your TVthat is not covered by the manufacturer’s warranty.Before attempting assembly or removal of the stand, unplug the AC powercord.To install the stand:1 Remove the stand from the box and place it on a table or bench.2 Hold your TV upright and align the stand column on the TV withthe stand groove on the stand, then insert the TV into the stand.3 Gently push downward on the TV until it clicks into place.Option DescriptionH-Pos Lets you adjust the horizontal position of the image tothe left or right.V-Pos Lets you adjust the vertical position of the image up ordown.Clock Lets you adjust the sample frequency of the image.Phase Lets you adjust the phase of the image to improve thefocus.Auto Lets you activate the auto adjustment setting, whichautomatically optimizes the image.StandStandStand columnStand groovePush downwards