Dynex DX-LCD22-09 User Manual

Also see for DX-LCD22-09: Service manual Guía del usuario Guide de l'utilisateur

22 SpecificationsSpecificationsSpecifications are subject to change without notice. Weight and dimensions shown areapproximate.Legal noticesFCC Part 15This device complies with Part 15 of the FCC Rules. Operation of thisproduct is subject to the following two conditions: (1) this device maynot cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesiredoperation.This equipment has been tested and found to comply within the limitsfor a class B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult the dealer or an experienced technician for help.FCC warningChanges or modifications not expressly approved by the partyresponsible for compliance with the FCC Rules could void the user’sauthority to operate this equipment.Double images or“ghosts” Use a highly directional antenna or cable TV.Good picture but nosound• Make sure that the sound is not muted.Press MUTE to cancel.• Make sure that the stereo mode is set toStereo or Mono.Audio noise Problems may occur if infraredcommunications equipment (such asinfrared cordless phones) are used near theTV. Move the infrared communicationsequipment away from the TV until the noiseis eliminated.Remote controlThe remote controldoes not work • Aim the remote control at the remotecontrol sensor.• Operate within about 15 feet of the TV, orreduce the light in the room.• Clear the path of the infrared beam.• The batteries may be weak. Replace thebatteries.• Make sure that the batteries are insertedcorrectly.Type LCD TVPanel 22” TFT LCDTV system NTSC-M, ATSCReceiving channels VHF 2-13, UHF 14-69, CATV 1-125, CADTV 1-135,DTV 2-69Audio multiplex BTSC systemPower requirement AC 120 V, 60 HzPower consumption 48 WDimensions(W × H × D)20.24 × 16.14 × 7.09 inches(514 × 410 × 180 mm)Weight 11.5 lbs (5.2 kg)Input terminals Composite video/audio L/R (1)S-Video (1)Component video/audio L/R (1)HDMI interface (1)VGA/Audio (1)Antenna (1)Output terminals Headphone jack (1)Control RS-232 (1)Problem Solution

/ 24

Related manuals for Dynex DX-LCD22-09