Dynex DX-PHD35 Quick Setup Manual

Also see for DX-PHD35: Manual User manual

Contents

3.5" PATA Hard DrivePower LEDBackup buttonActivity LEDUSB 2.0 B type12V DCPower switchScrewScrewUSB 2.0 A type connector USB 2.0 B type connectorQuick Setup GuideDX-PHD35 3.5" PATA Hard Drive Disk EnclosurePackage contents• USB 2.0 3.5" PATA hard drive enclosure• USB 2.0 cable A-B• AC power adapter• Utility CD with User Guide and Roxio BackOnTrack software• Accessories:ScrewdriverScrews (4)• User Guide• Quick Setup GuideSystem requirements• Computer with an available USB 2.0 port• 3.5" PATA hard drive• Windows 7, Windows Vista, and Windows XP operating system.• MAC OS X version 10.4 or higher operating system.For highest performance and reliability, install the latest updates and servicepack (SP). For Windows, go to the Start menu, then select Windows Update.FeaturesInstalling your hard drive in the enclosure1 Remove two screws on the left side of panel.2 Pull out the plastic end cap with the circuit board.3 Connect the drive to the 40-pin data connector and to the power connector onthe enclosure circuit board, then secure the drive to the rails with the fourscrews (provided).4 Place the hard drive with the plastic cap back into the aluminum housing andsecure it with the two screws you previously removed.Connecting the enclosure to your computerNote: Make sure you have already installed a hard drive into the enclosure beforeyou connect the enclosure to your computer.1 Plug the AC power adapter into the 12V DC jack, then plug it into an AC poweroutlet.2 Plug the USB B type connector into the enclosure, then plug the A typeconnector into one of the available USB 2.0 ports on your computer.3 Press the power button to turn on the enclosure. The operating systemautomatically detects and sets up the new drive. The power LED turns on whenthe enclosure/hard drive turns on.4 If the drive is correctly detected, a new drive letter is assigned.• For PCs, the new drive letter appears in My Computer.• For Macintosh computers, the new drive letter appears on your desktop.Note for Windows users: If you do not see an additional drive in your system,you must format the new drive. See the instructions below.Note for Macintosh users: If you do not see an additional drive in your system,select Disk Utilities from the Utilities folder, then select the external enclosureand format the drive to meet your requirements.5 If the drive is new and is not formatted, follow the steps below to format thedrive. Otherwise, continue to “Installing the backup software”.

/ 2

Related manuals for Dynex DX-PHD35