Eaton 9395 Installation And Operation Manual

Also see for Power Xpert 9395P: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual User and installation guide

Contents

INSTALLATIONEaton Power Xpert™ 9395P Sync Control Installation and Operation Manual P-164000502 Rev 13-2NOTE Complete the wiring to the X-Slot Relay Interface Card or Industrial Relay Card terminals beforeinstalling the cards in the Communication Bay in each of the UPS cabinets.4. Route wires through the strain relief bushing and connect to the terminals on theX-Slot Relay Interface Card in each of the UPS cabinets (see Figure 3‐8).5. Install the X-Slot Relay Interface Card or Industrial Relay Card into an open X-Slotcommunication bay on the front of the UPS (see Figure 3‐5). Refer to theapplicable Eaton 9395P UPS Installation and Operation Manual listed inparagraph 1.3 on for UPS cabinet access instructions.6. Verify the jumper is installed between Sync Control terminal TB1-40 and TB1-41(see Figure 3‐2).7. When all wiring is complete, close the door and secure the latch.C A U T I O NWhen connecting the bypass and load voltage from another model UPS to a Eaton 9395P UPS using the EatonSync Control accessory, use Phase A, Phase B, and Neutral connections from the other UPS. DO NOT connect theother model UPS Phase C bypass and load voltage to the Sync Control connection point when connecting to anEaton 9395P UPS.MISE EN GARDE!Lorsque vous connectez le dispositif de dérivation et la tension de la charge d’un autre modèle d’UPS à unonduleur UPS 9395 d’Eaton à l’aide du module Sync Control d’Eaton, utilisez la phase A, la phase B et laconnexion du neutre de l’autre UPS. NE connectez PAS le dispositif de dérivation et la tension de la charge de laphase C de l’autre modèle d’UPS au point de raccordement du Sync Control lors de la connexion à l'UPS 9395d’Eaton.