Eaton CA22106060000R6 Installation And Operation Manual

Also see for Power Xpert 9395: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Eaton Power Xpert 9395P UPS (300 kVA, 300 kW) Installation and Operation Manual P-164000563 Rev 1 www.eaton.com/powerquality 3-1Chapter 3 UPS Installation Plan and UnpackingUse the following basic sequence of steps to install the UPS:1. Create an installation plan for the UPS system (Chapter 3).2. Prepare your site for the UPS system (Chapter 3).3. Inspect and unpack the UPS sections (Chapter 3).4. Unload and install the UPS sections, and wire the system (Chapter 4).5. Install features, accessories, or options, as applicable (Chapter 5).6. Complete the Installation Checklist (Chapter 4).7. Have authorized service personnel perform preliminary operational checks andstart up the system.NOTE Startup and operational checks must be performed by an authorized Eaton Customer ServiceEngineer, or the warranty terms specified on page W-1 become void. This service is offered as part of thesales contract for the UPS. Contact an Eaton service representative in advance (usually a two-week notice isrequired) to reserve a preferred startup date.3.1 Creating an Installation PlanBefore installing the UPS system, read and understand how this manual applies to thesystem being installed. Use the procedures and illustrations in paragraph 3.2 andChapter 4 to create a logical plan for installing the system.3.2 Preparing the SiteFor the UPS system to operate at peak efficiency, the installation site should meetthe environmental parameters outlined in this manual. If the UPS is to be operated atan altitude higher than 1000m (3300 ft), contact an Eaton service representative forimportant information about high altitude operation. The operating environment mustmeet the weight, clearance, and environmental requirements specified.3.2.1 Environmental ConsiderationsMake sure that the environment for the 9395P UPS meets the following operatingrestrictions:The environmental requirements specified below are for the air at the intake ports ofthe 9395P, and are the maximum, not to exceed, ratings. There shall be at least a 1.8°F (1.0°C) difference between the dry bulb temperatureand the wet bulb temperature, at all times, to maintain a non-condensingenvironment. The maximum rate of temperature change shall be limited to 3°F over 5 minutes(36°F/hour), based on the ASHRAE Standard 90.1-2013.Observe caution regarding UPS operating environmental conditions. The newer, moreenergy efficient data center cooling methods (such as air side economization) cancreate much wider ranges of temperature and Relative Humidity (RH) in the UPSroom and/or data center.Figure