Eaton COOPER POWER SERIES Installation, Operation And Maintenance Instructions

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER SERIES Installation, Operation And Maintenance Instructions Manual pdf 30 page image

Spare partsOrdering InformationWhen ordering replacement parts or field-installationaccessories for your VR-32 voltage regulator, provide thefollowing information:●● Regulator serial number (found on nameplate)●● Regulator catalog number (found on nameplate)●● Part number if known●● Description of each part●● Quantity of each part requiredRefer to Figure 23 for part identification of high-voltagebushings.Refer to the following Service Information documents forinformation on Eaton’s Cooper Power series tap-changermaintenance and replacement parts:●● S225-12-1, QD3 Quik-Drive Voltage Regulator Tap-ChangerManual●● S225-12-2, QD5 Quik-Drive Voltage Regulator Tap-ChangerManual●● S225-12-3, QD8 Quik-Drive Voltage Regulator Tap-ChangerManualTERMINAL CAPTERMINAL CAP GASKETCOMPLETE BUSHINGASSEMBLY W/HARDWAREBUSHING (PORCELAIN)BOLTCLAMP RINGTANK COVERROD ASSEMBLYCONICAL SPRING WASHERWASHERHEX JAM NUTBUSHING GASKETSPRINGFigure 23 High-voltage bushing (S, L, and SL)TroubleshootingFor troubleshooting instructions, refer to Service InformationMN225003EN, CL-7 Voltage Regulator Control Installation,Operation, and Maintenance Instructions.For additional assistance, call the Voltage Regulator Supportline at 866-975-7347 (calls from outside the U.S.:262-896-2591) or e-mail questions to RES-VRSupport@Eaton.com.Regulator control reverse power flow testPurposeThe purpose of this procedure is to test the voltageregulator and control to ensure correct operation inresponse to reverse power flow.Required equipment●● Clamp-on ammeter●● Appropriate cable leads●● 2 – 120 V variable power suppliesProcedureWARNINGHazardous Voltage This procedure must only beperformed on a regulator that has been removedfrom service Failure to comply can cause seriousinjury or death VR-T224 01. Remove the unit from service as described in “Removalfrom service” on page 11.WARNINGHazardous Voltage When troubleshooting energizedequipment, protective gear must be worn to avoidpersonal contact with energized parts Failure tocomply can cause serious injury or death VR-T213 02. Conduct this test with the regulator located in themaintenance shop or other suitable location.WARNINGHazardous Voltage The regulator tank must besolidly earth grounded Failure to comply cancause severe personal injury and equipmentdamage VR-T225 03. Ground the regulator tank.4. Connect a cable sized for the regulator rated currentbetween the Source (S) and the Load (L) bushings.5. Install a clamp-on ammeter on the cable between the Sand L bushings to verify the current during the test.26VR-32 Voltage Regulator with Quik-Drive™ Tap-ChangerInstallatIon, operatIon, and MaIntenance InstructIons MN225008EN February 2017