Eaton COOPER POWER SERIES Installation, Operation And Maintenance Instructions

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER SERIES Installation, Operation And Maintenance Instructions Manual pdf 5 page image

IntroductionEaton’s Service Information MN225008EN provides theinstallation, operation, and maintenance instructions for itsCooper Power™ series VR-32 voltage regulator with theQuik-Drive™ tap-changer.Read this manual firstRead and understand the contents of this manual andfollow all locally approved procedures and safety practicesbefore installing or operating this equipment. Read andunderstand the manual detailing the installation andoperation of the control used with this regulator. Refer toService Information MN225003EN, CL-7 Voltage ControlInstallation, Operation, and Maintenance Instructions, forinformation on the CL-7 voltage regulator control.Additional informationThese instructions cannot cover all details or variations inthe equipment, procedures, or processes described norprovide directions for meeting every possible contingencyduring installation, operation, or maintenance. For additionalinformation, please contact your Eaton representative.Acceptance and initial inspectionThe regulator is thoroughly tested and inspected at thefactory. It is carefully calibrated, adjusted, and in goodcondition when accepted by the carrier for shipment.Upon receipt of the regulator shipment, before unloading, athorough inspection should be made for damage, evidenceof rough handling, or shortages. The position indicator,junction box, arrester, radiators and bushings should allbe inspected for evidence of damage. Should this initialinspection reveal evidence of rough handling, damage, orshortages, it should be noted on the bill of lading and aclaim should immediately be made with the carrier. Also,notify your Eaton representative.Handling and storageBe careful during handing and storage of equipment tominimize the possibility of damage. If the regulator will notbe placed into immediate service, it can be stored withminimal precautions. Store the unit where the possibility ofmechanical damage is minimized.WARNINGEquipment Damage Lift the entire unit only with tank-mounted lifting lugs The cover may warp or fractureif the cover-mounted lifting eyes are used to lift theentire unit causing death or severe personal injury orequipment damage VR-T218 0UnloadingWhen an overhead crane is used for unloading, theregulator must be lifted by means of a sling and spreaderbar utilizing the tank-mounted lifting lugs, which are shownin Figure 2. Do not lift the entire unit with the lifting eyes onthe cover. The lifting eyes are only to be used to untank theinternal assembly that is attached to the cover.StandardsEaton’s Cooper Power series regulators are designed andtested in accordance with the following standards:IEEE Std C37.90.1-2012™ standardIEEE Std C37.90.2-2004™ standardIEEE Std C57.13-2008™ standardIEEE Std C57.15-2009™ standardIEEE Std C37.91-2011™ standardIEEE Std C57.131-2012™ standardEN 50081-2EN 61000-4IEC 60068-2IEC 60214-1IEC 610255-5Quality standardsISO 9001 Certified Quality Management System1VR-32 Voltage Regulator with Quik-Drive™ Tap-ChangerInstallatIon, operatIon, and MaIntenance InstructIons MN225008EN February 2017