Eaton COOPER POWER Series Installation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Contents

Eaton COOPER POWER Series Installation Instructions Manual Manual pdf 6 page image

2Edison m o d u l a r f u s e ( E M F ) installation instru c t ionsINSTALLATION INSTRUCTIONS MN132031EN November 2016Kit Item # Part QuantityNote: For use with top-hat channel base only.13 pocket 214 5/16-18 X 1/2” cap screw 215 detent 2Extended Stand-Off Channel Bracket with PocketEMFBRKS316 stand-off bracket 217 5/16-18 X 3/4” hex bolt 818 5/16” lock washer 819 pocket 220 5/16-18 X 1/2” cap screw 221 detent 2Foot BracketsNote: For use with standard channel base only.Adjustable Foot BracketEMFBRKF122 adjustable bracket 223 5/16-18 X 5/8” hex bolt 824 5/16” lock washer 825 5/16” nut 426 foot bracket 2Assembly and installation! WARNINGHigh Voltage All associated apparatus must bede-energized prior to any hands-on installation ormaintenance of this equipment Failure to do so couldresult in contact with high voltage, which will causedeath or severe personal injuryRefer to Table 1 for parts description.Channel basesThe standard channel base (CB) and the top-hat channelbase (HB) are compatible with the quick-release clamp (QR),the bolted clamp (BC), and the extended stand-off channelbracket with pocket (S3). The rotatable stand-off pocket (S1)is used with the top-hat base only. The foot bracket (F1) isfor use with the standard channel base only. The top-hatchannel base is mounted without a foot bracket.Identify the channel base type. Refer to Figures 2 and 3.Figure 2 Standard channel base (Item 1)Figure 3 Top-hat channel base (Item 2)ClampsUsing the standard channel base (Item 1) or the top-hatchannel base (Item 2), attach the clamps to the base. Theoptions include the Quick-Release clamp and the bolted clamp.Quick-Release clamp optionotee:N The Quick-Release Clamp is shipped with a cotter pinfor securing the clamp. This is a small part. Locate thecotter pin in the shipping bag and retain for later use.1. Site the base brackets (Item 3) to the base (Item 1 or 2)for placement. See Figures 4 and 5.2. Attach the base bracket (Item 3) to the base (Item 1 or 2)with a hex-head wrench using 3/8-16 X 1” cap screws and3/8” lock washers (Items 5 and 6). See Figure 6.Figure 4 Base bracket placement on standardchannel baseBase bracket(item 3)Figure 5 Base bracket placement on top-hat channelbaseTable 1 Parts Description (continued)