Eaton CROUSE-HINDS Champ NPFMA20L Installation & Maintenance Information

Also see for Crouse-hinds series: Operating instructions Instruction manual Operating instructions Operating instructions Instruction manual

Contents

replacement parts

Eaton CROUSE-HINDS Champ NPFMA20L Installation & Maintenance Information Manual pdf 2 page image

WARNINGTo avoid overheating of the floodlight:Do not position the floodlight beyond the aiming range limits.IF 1849 • 03/19 Copyright® 2019, Eaton’s Crouse-Hinds Division Page 2WIRING DIAGRAM3. Re-install back cover/heat sink and tighten all nine (9) mounting screws to 22 in.-lbs. (2.5 N-m). Be sure wires are not pinched during cover installation.• Replace any damaged or missing cover screws. Use only stainless steel#10-24 x 0.75”cover screws.4. To make final vertical adjustment, loosen the pivot bolts on the floodlight yoke toposition floodlight at the desired angle. See Figure 3.NOTE: Yoke mounting range is 45 degrees back to 60 degrees forward.5. Rotate the floodlight housing to the desired position.6. Tighten the two (2) 1/2-13 pivot bolts to 45 ft.-lbs. (61 N-m).7. Tighten the two (2) 5/16-18 angle marker bolts to 138 in.-lbs. (15.6 N-m).8. Turn power on.Figure 2SUPPLY WIRELINENEUTRALPOSITIVENEGATIVEGROUNDP1 -P4 +LED PCB 1- (BLUE) + (RED)N(WHITE)L(BLACK)N LOUTPUTINPUTDRIVERG(GREEN)GREEN/YELLOWWHITE(DC+)BLACK(DC-)PURPLE (+)GRAY (-)LNGG(YELLOW/RED)(YELLOW/BLACK)2X2 POLE SPLICECONNECTOR3X3 POLE SPLICECONNECTORBLACK/WHITEHEATSINK3X2 POLE SPLICECONNECTORMAINTENANCE• Perform visual, electrical and mechanical inspections on a regular basis. Theenvironment and frequency of use should determine this. However, it isrecommended that checks be made at least once a year. We recommend anElectrical Preventive Maintenance Program as described in the National FireProtection Association Bulletin NFPA 70B: Recommended Practice for ElectricalEquipment Maintenance (www.nfpa.org).• The lens should be cleaned periodically to ensure continued lighting performance.To clean, wipe the lens with a clean, damp cloth. If this is not sufficient, use amild soap or a liquid cleaner such as Collinite NCF or Duco #7. Do not use anabrasive, strong alkaline or acid cleaner. Damage may result.• Visually check for undue heating evidenced by discoloration of wires or othercomponents, damaged parts or leakage evidenced by water or corrosion in theinterior. Replace all worn, damaged or malfunctioning components and cleangasket seals before putting the luminaire back into service.• Electrically check to make sure that all connections are clean and tight.• Mechanically check that all parts are properly assembled.REPLACEMENT PARTSCrouse-Hinds Champ LED Floodlights are designed to provide years of reliable lightingperformance. However, should the need for replacement parts arise, they are availablethrough your authorized Crouse-Hinds distributor. Assistance may also be obtainedthrough your local Crouse-Hinds Sales Representative or the Crouse-Hinds SalesService Department, 1201 Wolf Street, Syracuse, New York 13208, Phone 866-764-5454.60°45°105°VERTICALAIMING RANGE60° BEFOREVERTICAL45° PASTPIVOT1/2-13 BOLT5/16-18 ANGLE BOLTLOOSEN BOLTS TO SETFLOODLIGHT ANGLEFigure 3