Eaton Crouse-hinds series Instruction Manual

Also see for Crouse-hinds series: Operating instructions Operating instructions Operating instructions Instruction manual Software manual

Contents

Eaton Crouse-hinds series Instruction Manual Manual pdf 11 page image

DRAFT - 04 March 2016INM MTL GECMA RT COM rev 2115 3 Electrical connections5 3 1 DC power connectionThe MTL GECMA RT COM module must be powered from an MTL GECMA WS PSUpower supply module that is normally fitted alongside the RT COM module as shownin the picture on the previous page ‘5.2 Mechanical Installation’. Refer also to the WSPSU module installation manual.To connect the MTL GECMA RT COM module to the PSU:1. Feed the RT COM power cable through the right-hand (M16) cable gland ofthe PSU.2. Connect the three wires to the spring-clamp connectors of the power supplyensuring that the cable colours are in the same order as the ones shown inthe diagram below.Colour code Pin assignment FunctionWhite 22V DC Output FusedRed 5V DC InputBlack 0V Input3. Tighten the cable gland nut to the recommended torque to ensure anadequate seal around the cable.When all connections have been made on the PSU, replace the cover securely usingthe four screws provided and tighten them to a maximum torque setting of 2 Nm.