Eaton HALO FT1850LW Instruction Manual

Eaton HALO FT1850LW Instruction Manual Manual pdf 1 page image

Questions?/Des questions?/¿Preguntas? 1-800-334-6871 ConsumerProducts@eaton.com1PACKAGING CONTENTS/CONTENU D E L’EMBALLAGE/CONTENIDO D E L P A Q U E TEInstruction Manual / Manuel d’instructions/ InstruccionesFOR BEST RESULTS• Install light 10-15 feet above the ground.• When installing two fixtures on one switch,make sure the switch is rated for at least a1 A inductive load.MOUNTING AND WIRING YOUR FIXTUREWARNING: Risk of electric shock. Disconnectpower at fuse or circuit breaker before installingor servicing.NOTE: Fixture can be wall or eave mounted (Fig. 1).NOTE: Mounting Bracket (B) mounts to recessedmounted standard junction boxes (Fig. 2). Junction boxmust be at least 1-1/2 inch in depth for properinstallation for recessed mount application.1. Line up the slotted holes on the mounting bracket (B)with the holes on your junction box. Using either (2)#6 screws or (2) #8 screws (C) (depending on size ofthe holes in your junction box), attach the mountingbracket (B) to your junction box (Fig. 3).2. Connect house ground wire to mounting bracketground wire using a wire nut (E) provided (Fig. 3).3. Connect fixture black wire to house black wire, andfixture white wire to house white wire, using the wirenuts (E) provided (Fig. 4).4. Level and secure the mounting bracket arm bytightening the rotation clamp screws and attachfixture (A) to the mounting bracket (B) using (2)decorative cap nuts (D). Be sure no loose wiresremain sticking out from underneath the coverplate.5. Move the heads to aim light where desired.6. Apply silicone caulk around the edge of thecoverplate to provide a watertight seal from rainand moisture.7. Turn on power at main fuse/breaker box.ITEMS REQUIRED(Purchase separately)• Phillips screwdriver• Outdoor weatherproof silicone caulkingIMPORTANT SAFETY INSTRUCTIONSWhen using product, basic precautions should always be followed, including the following:• Heed all warnings, including below warnings AND those included on product.• Save these instructions and warnings.• For outdoor use only.• cULus LISTED for wet location.• Disassembling your fixture will void the warranty.• Your fixture is prewired and preassembled for easy installation.• Read and follow these instructions.• Risk of fire/electric shock. If not qualified, consult an electrician.• Disconnect power at fuse or circuit breaker before installing or servicing.CAUTION• Connect fixture to a 120 volt, 60 Hz power source. Any other connection voidsthe warranty.• Fixture should be installed by persons with experience in household wiring or by aqualified electrician. The electrical system, and the method of electrically connectingthe fixture to it, must be in accordance with the National Electrical Code and localbuilding codes.• Fixture designed for wall or eave mount to a junction box only. Mount fixture to agrounded, recessed-mounted standard junction box marked for use in wet locations.• Do not mount below 5 feet.• This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may causeundesired operation.WARNING: FCC Regulations state that any unauthorized changes ormodifications to this equipment not expressly approved by the manufacturercould void the user’s authorization to operate this equipment.SAVE THESE INSTRUCTIONS.FT1850LFT1850LHFT2850LFT2850LH(Bronze/Bronze/Bronce)A. Light fixtureAppareil d’éclairageAccesorioENGLISHC. (2) #6-32 x 3/4 in. and (2) #8-32 x 3/4 in. junction box screws(use the size that fits your junction box)(2) vis nº 6 de 32 x 3/4 po et 2 vis nº 8 de 32 x 3/4 po pouboîtier de jonction (choisissez la dimension convenantà votre boîtier de jonction)(2) Tornillos #6-32 x 3/4 pulg. y (2) tornillos #8-32 x 3/4pulg. para montaje de la caja de conexiónes (utilice eltamaño que mejor se adecue a su caja de conexiónes)E. (3) Wire nuts(3) Serre-fils(3) Tuercas para cablesD. (2) Decorative cap nuts(2) Écrous borgnes décoratifs(2) Tuercas decorativasWARNINGB. Mounting bracketSupport de montageSoporte de montaje1AWall mountEave mount3 B1BRound1-1/2 in.Octagonal1-1/2 in.2FT1850LWFT1850LWHFT2850LWFT2850LWH(White/Blanc/Blanco)4A

/ 4

Related manuals for Eaton HALO FT1850L