Eaton LUMARK Crosstour MAXX Installation Instructions Manual

Also see for LUMARK Crosstour MAXX: Installation instructions

INS #Brand Logoreversed out ofblackINS #IB514002ENInstallation Instructions - Crosstour MAXX Emergency EgressOptionInstructions d’installation - Luminaire Crosstour MAXX avec optionde secoursInstrucciones de instalación - Opción para Salida de Emergencia deCrosstour MAXXIMPORTANT: Read Before Installing fixture. Retain for Future Reference.IMPORTANT SAFEGUARDS: When using electrical equipment, basic safety precautions should always be observedincluding the following.SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes andordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure underinstallation section.READ AND FOLLOW ALL SAFETY INSTRUCTIONS.1. Do not mount near gas or electric heaters.2. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin oreyes, flush acid with fresh water and contact a physician immediately.3. Equipment should be mounted in locations and at heights where it will not be subjected to tampering byunauthorized personnel.WARNINGMake certain power is OFF before starting installationor attempting any maintenance.WARNINGMake certain power is OFF before starting installationor attempting any maintenance. Risk of fire/electricshock. If not qualified, consult an electrician.WARNINGRisk of Electric Shock—Disconnect power at fuse orcircuit breaker before installing or servicing.WARNINGRisk of Burn—Disconnect power and allow fixture tocool before servicing.WARNINGDO NOT mount luminaire within 6” of a combustiblesurface. DO NOT handle luminaire by the lens.WARNINGRisk of Personal Injury— Fixture may becomedamaged and/or unstable if not installed properly.Tighten all fixture components to their recommendedtorque values. Do not lift pole into place by securinglifting device to lighting fixture or mounting arm.ote:N These instructions do not claim to cover alldetails or variations in the equipment, procedure,or process described, nor to provide directionsfor meeting every possible contingency duringinstallation, operation or maintenance. Whenadditional information is desired to satisfy aproblem not covered sufficiently for user’s purpose,please contact your nearest representative.ote:N Specifications and dimensions subject to changewithout notice.