Eaton Powerware 9125 User Manual

Also see for Powerware 9125: Reference guide User guide User guide User guide Installation guide

INSTALLATIONEATON Powerware® 9125 Two-in-One UPS (700–2000 VA) User’s Guide S 164201514 Rev B www.powerware.com 25Installing the UPSNOTE Do not make unauthorized changes to the UPS or accessories; otherwise, damagemay occur to your equipment and void your warranty.Figure 11 shows a typical installation only. See “UPS Rear Panels” onpage 29 for the rear panel of each model.To install the UPS and optional EBMs:1. If installing an optional EBM, continue to Step 2; otherwise, skip toStep 3.2. Plug the EBM cable(s) into the battery connector(s) as shown inFigure 11. Up to four EBMs may be connected to the UPS.UPS BatteryConnectorPower CordEBM CableOutput ReceptaclesCommunication PortUPSEBMEBMEBM Battery ConnectorsFigure 11. Typical UPS Installation with Two EBMs3. If you are installing power management software, connect yourcomputer to the UPS communication port using the suppliedcommunication cable.4. Plug the equipment to be protected into the appropriate UPS outputreceptacles (see page 46 for more information on load segments).NOTE DO NOT protect laser printers with the UPS because of the exceptionally high powerrequirements of the heating elements.