Eaton Powerware 9305 UPS Quick Start Instructions

Figure 12. Configure Adapter SettingsFigure 13. Set ConnectUPS Adapter IP AddressFigure 14. Save and ExitFigure 15. ConnectUPS Adapter Summary PageEATON Powerware ® ConnectUPSt Web/SNMP Adapter (E Model) Quick Start Instructions 164950186 Rev A 9Section 4Configure the AdapterTo configure the adapter after you have connected it:1. Type 1 on the Main Menu to display the Web/SNMP AdapterSettings screen (see Figure 12).2. Type 1 to display the Set the IP Address, Gateway Addressand MIB System Group screen (see Figure 13).3. To set the IP Address, type 1 and press Enter. Type the IPAddress and press Enter (see the Checklist).4. Type 0 to return to the previous menu.5. Repeat Steps 3 and 4 to set the Gateway Address andNetwork Mask.6. Change any other options as needed for your particularconfiguration by typing the corresponding number shown inthe menu.Each Configuration Menu setting is described in detail in theAppendix of the ConnectUPS Web/SNMP Card User’s Guide.You can change the other options later if you prefer.7. Type 0 until you return to the Main Menu (see Figure 14).8. Type 0 to save all settings and exit the adapter configuration.9. Verify network communication by using a Web browser (seeFigure 15). Type the IP Address of your adapter and selectGo. The ConnectUPS Adapter summary page opens.NOTE Once the adapter is reachable on the network, youcan use a Web browser, Telnet, or similar utility to adjust anyof the configuration settings. The menus are identical tothose seen during serial configuration and arepassword-protected for Superuser access only.

/ 12

Related manuals for Eaton Powerware 9150 UPS