RESPONDING TO SYSTEM EVENTSEaton 9390 UPS (100–160 kVA) Installation and Operation Manual 164201604 Rev E www.eaton.com/powerquality 11-5Table 11‐2. NoticesMessage Horn Phone Relay Log* IndicationAutomatic Shutdown Pending 1 No No A Information OnlyAutomatic Shutdown Pending OK OFF No No A Condition ClearedAutomatic Startup Pending 1 No No A Information OnlyBattery Current Limit 1 No No HA Information OnlyBattery Current Limit OK Off No No HA Condition ClearedBattery Voltage High 1 1 No HA Information OnlyBattery Voltage High OK Off No No HA Condition ClearedBattery Voltage Low 1 No No HA Information OnlyBattery Voltage Low OK Off No No HA Condition ClearedBypass AC Over Voltage 1 No No HA Information OnlyBypass AC Over Voltage OK Off No No HA Condition ClearedBypass AC Under Voltage 1 No No HA Information OnlyBypass AC Under Voltage OK Off No No HA Condition ClearedBypass Phase Rotation 1 No No HA Information OnlyBypass Phase Rotation OK Off No No A Condition ClearedBypass Source Out of Tolerance 1 No No HA Investigate UPSBypass Source Out of Tolerance OK Off No No HA Condition ClearedBypass Under or Over Frequency 1 No No HA Information OnlyBypass Under or Over Frequency OK Off No No HA Condition ClearedCharger Off Command 1 No No HA Information OnlyCharger On Command 1 No No HA Information OnlyCharger Over Voltage or Current 1 No No HA Information OnlyCharger Tripped 1 No No HA Information OnlyCharger Tripped OK Off No No HA Condition ClearedCheck Battery 1 No No HA Information OnlyCheck Battery OK Off No No HA Condition ClearedCheck Modem 1 No No HA Information OnlyCheck Modem OK Off No No HA Condition ClearedDC Link Over Voltage 1 1 No HA Information OnlyDC Link Over Voltage OK Off No No A Condition ClearedDC Link Under Voltage 1 No No HA Information OnlyDC Link Under Voltage OK Off No No HA Condition ClearedEmergency Transfer To Bypass 1 No No HA Information OnlyEmergency Transfer To Bypass OK Off No No A Condition Cleared*Log codes indicate where the UPS records the event: H = History log; HA = History and Active logs; and A = Active log only.
