Eaton Powerware User Manual
Also see for Powerware Series: Installation and operation manualUser guideUser guideUser guideUser guide
            | |
Contents |
SMOKE DETECTOREATON Powerware® Smoke Detector User’s Guide S 164201680 Rev 1 58. Push and hold the test button for approximately two seconds totest the smoke detector. The smoke detector sounds a loudpulsating alarm.If the alarm does not sound, replace the battery.9. Loosen the screws on the TH-Module (see Figure 1).Alarm 1 Alarm 2Figure 1. Adjusting TH-Module Screws10. Connect the blue and orange wires of the smoke detector to theTH-Module alarm 1 or alarm 2 connectors, then tighten theTH-Module screws (see Figure 2).Blue Wire Orange WireFigure 2. TH-Module with Smoke Detector Wires11. If you are installing additional smoke detectors, repeat Steps 1through 10. |
Related manuals for Eaton Powerware Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine