Eaton Streetworks SDL LED Arm Mount Installation Instructions Manual

Brand Logoreversed out ofblackINS #IB516002ENInstallation Instructions – SDLInstructions d’installation – SDLInstrucciones de instalación – SDLRisk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of thisproduct must be performed by a qualified electrician. This product must be installed in accordancewith the applicable installation code by a person familiar with the construction and operation of theproduct and hazards involved.Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attemptingany maintenance. Disconnect power at fuse or circuit breaker.Risk of Fire- Refer to product label for specific minimum supply conductor requirements.Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.Failure to comply with these instructions may result in death, serious bodily injury and property damage.WARNINGotee:N These instructions do not claim to cover all details or variations in the equipment, procedure, or processdescribed, nor to provide directions for meeting every possible contingency during installation, operationor maintenance. When additional information is desired to satisfy a problem not covered sufficiently foruser’s purpose, please contact your nearest representative.otee:N This lighting fixture has been shipped complete with one of several mounting options. Please follow theinstallation instructions specific to the catalog part that you ordered.otee:N Care must be taken not to set lighting fixture down on optical lenses or lift the fixture in the lens area.otee:N Specifications and dimensions subject to change without notice.otee:N If the light fixture is ordered with the CBP (Cold Weather Battery Pack) option, then “this luminaire is pro-vided with a factory installed emergency lighting pack and must be serviced by a person familiar with theconstruction and operation of product and hazards involved”.DISCLAIMER OF LIABILITYe: Eaton assumes no liability for damages or losses of any kind that may arise from theimproper, careless, or negligent installation, handling or use of this product.NOTICEe: Green ground wire provided in proper location. Do not relocate.ATTENTION Receiving Departmente: Note actual fixture description of any shortage or noticeable damage ondelivery receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must befiled within 15 days of delivery. All damaged material, complete with original packing must be retained.Safety: This fixture must be wired in accordance with the National Electrical Code and applicable local codes andordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure underinstallation section.APPLICATIONS: This lighting fixture is designed for outdoor lighting services, and should not be used in areaof limited ventilation or inside high ambient temperature enclosures. It must be stored in a dry location prior toinstallation. Do not expose lighting fixture to rain, dust or other environmental conditions prior to installationand insertion of photo control or shorting cap (if so equipped). Best results will be obtained if installed andmaintained according to the following recommendations.