Eaton UPS Sidecar Powerware 9390 Installation And Operation Manual

Also see for Powerware Series: User guide User guide User guide User guide Installation and operation manual

Contents

EATON Powerware® 9390 UPS Sidecar Installation and Operation Manual S 164201586 Rev E www.powerware.com 2-1Chapter 2 Installing the UPS Sidecar2.1 Installation Plan and UnpackingRefer to the applicable Powerware 9390 installation and operation manual, listed inparagraph 1.5, for installation planning and unpacking.2.2 Preliminary Installation InformationW A R N I N GInstallation should be performed only by qualified personnel.Refer to the following while installing the UPS Sidecar:S Appendix A contains installation drawings and additional installation notes.S Dimensions are in millimeters and inches.S The conduit landing plates are to be removed to add conduit landing holes, orremove knockouts, as required. Plate material is 16 gauge steel (1.5 mm/0.060”thick).S Refer to the applicable Powerware 9390 installation and operation manual, listed inparagraph 1.5, for UPS cabinet installation, wiring information, and conduit andterminal locations.2.3 UPS Sidecar Installation – Maintenance Bypass Configuration2.3.1 Installing the UPS Cabinet with UPS SidecarThe UPS Sidecar is a factory-installed integral part of the standard UPS cabinet. Referto the applicable Powerware 9390 installation and operation manual, listed inparagraph 1.5, for UPS cabinet installation.2.3.2 Installing Maintenance Bypass Power WiringNOTE Remove the UPS Sidecar top or bottom conduit landing plate to drill or punch conduit holes, orremove knockouts (see Drawing 164201546-5 starting on page A-27).NOTE Refer to the applicable Powerware 9390 installation and operation manual, listed in paragraph 1.5,for UPS cabinet wiring information and conduit and terminal locations.NOTE If input or output neutrals are required, wire the neutrals to the neutral terminals located inside theUPS cabinet.NOTE Wire grounds to the ground terminals located inside the UPS cabinet.1. Verify the UPS system is turned off and all power sources are removed. Refer tothe applicable Powerware 9390 installation and operation manual, listed inparagraph 1.5, for shutdown instructions.2. If not already removed, remove the screw securing the bottom of the UPSSidecar front panel (see Figure 2-1). Lift up the panel and remove.Figure