Eaton XP-503 User Manual

Also see for XP-503: Manual Instruction leaflet User guide

Contents

4 Installation4.4 InstallingXP-503 12/2014 MN048014-EN www.eaton.com 23 IP-65-tight built-in mounting- Peripheral gasket at the back of the front frame on the display housingPolyurethane foam gasketMaterial: RAKU-PUR 31-3117, blackAbb. 4 Polyurethane foam gasket Device holding brackets- The purpose of the device holding brackets is to secure the built-in mounting panel PC onto acontrol panel, etc. To this end, the brackets must be hooked into the display housing sidewaysand screwed against the control panel door.- Together with the polyurethane foam gasket, these holding brackets are the main elementinvolved in achieving an IP65 degree of protection.- The holding brackets' intended locations have been selected in such a way as to ensure that thebrackets will push against the center of the peripheral polyurethane foam gasket.- The holding brackets are included as accessories with the device.1-mm stainless steel sheetM4 x 25 DIN 914 Allen set screw, galvanizedAbb. 5 Device holding bracketCAUTIONTorque: 0.6 – 0.7 NmWhen tightening the M4 x 25 DIN 914 Allen set screw