Page 6Carries out a full system set*.Sets part set B, C or D*.A Hold Up Alarm (HUA) isstarted when both of thesekeys are pressed (if enabledby the installer).*This is the default action; the installer canconfigure these keys to operate outputs.About the standby screenWhen the system is idle (either while setor unset), the display shows the “standbyscreen”. For example:i-on Compact10:43 03/06/2017Setting the systemReadying the system to start an alarm ifsomeone moves into a protected area iscalled “setting” the system.You can set your system using a variety ofdifferent methods, depending on systemconfiguration. The following explains atypical method using the control unit.Note: Please refer to the Administrationand User Manual for full details.1. Enter your access code or present yourproximity tag at the control unit. If youenter your access code, the displayshows a * for each completed digit:Enter Access Code:(* )2. If setting options are displayed, youcan press or followed by tochoose the option you require:Setting OptionsFull Set•Full Set: To set the whole system.Alternatively, press the A key*.•Part Set B\C\D: To set part set B, C orD only. Alternatively, press the B, Cor D key*.*Your installer may have configuredthe system to allow you to quick setusing A, B, C or D without entering anaccess code or presenting a proximitytag first.3. You will hear a continuous exit tone(unless the system is configured forsilent or instant setting).The system sets when one of thefollowing occurs, depending on howthe system is configured:• Immediately.• After a period of time.• When you exit the premises.The A (full set), or B, C or D (part set)key illuminates to indicate the setstatus (unless disabled by the installer).Unsetting the systemDisarming the system so that peoplecan move freely is called “unsetting” thesystem.To unset the system from the control unit:1. Enter through the designated entryroute. Do not stray from this route –you may cause an alarm.2. If you hear a tone, go directly to thecontrol unit, since you will have limitedtime to unset the system before itgenerates an alarm.3. Enter your access code or present yourproximity tag.Managing alarmsIf there is an alarm, you will need tosilence the sirens and sounders (if they arestill running), acknowledge the cause of thealarm and reset the system.Note: Please refer to the Administrationand User Manual for full details.