Eaton i-on40 Installation Manual

Also see for i-on40: Quick user guide Administrator's and user guide

Installation i-on40Page 20Step 9. Commission theSystemAfter installing the control unit you shouldcommission the alarm system as follows:1. Use the Installer Menu (see Chapter 4) toteach the control unit the identity of its radiodetectors and any other peripherals. See theinstallation instructions supplied with eachdetector or peripheral.2. Install detectors and peripherals at theirselected locations.3. Use the Installer Menu – Test option to:a) carry out a walk test of the detectors.b) test the operation of any other peripherals.4. Program the system to suit user requirements.See the i-on Range Engineering Guide for adetailed description of the Installer Menu.5. Assemble and close the control unit:a) Hook the lid of the control unit into thebottom of the case.b) Close the lid and then tighten the two fixingscrews.NOTE: It is possible, for convenience, to placelinks over tamper contacts to inhibit tamper alarmduring installation. Because of this feature makesure you test all lid tampers before completinginstallations, to ensure that no links are left fitted.Figure 37 Replacing the control unit lid.6. Leave the Installer Menu.The red LEDs should go out, and the rim ofthe navigation keys glow green. The system isnow ready to hand over to the user.7. Instruct the user on how to operate thesystem. See the i-on Range Administrator’sGuide. If necessary, show them how to set thetime and date on the system.Remember to leave the i-on RangeAdministrator’s Guide with the user.123