Echo HCA-265 Operator's Manual

Also see for HCA-265: Spesifications Operator's manual

Shaft hedge Clipper 19OperatOr’S Manualspark plugLevel 2.Tools Required: T-Wrench, feeler gauge, soft metal brushParts Required: REPOWERTM Tune-Up KitIMPORTANTUse only NGK BPM-8Y spark plug (BPMR-8Y in Canada) other-wise severe engine damage may occur.1. Remove spark plug and check for fouling, worn and roundedcenter electrode.2. Clean the plug or replace with a new one. DO NOT sand blast toclean. Remaining sand will damage engine.3. Adjust spark plug gap by bending outer electrode.4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).coolIng systemLevel 2.Tools required: Cross Head Screwdriver, 3 & 4 mm Hex Wrench,Cleaning Brush, 25 - 50 mm (1 - 2 in.)Parts Required: None if you are careful.IMPORTANTTo maintain proper engine operating temperatures, cooling airmust pass freely through the cylinder fin area. This flow of aircarries combustion heat away from the engine.Overheating and engine seizure can occur when:• Air intakes are blocked, preventing cooling air from reaching thecylinder.• Dust and grass build up on the outside of the cylinder. This build upinsulates the engine and prevents the heat from leaving.Removal of cooling passage blockages or cleaning of cooling fins isconsidered “Normal Maintenance.” Any failure attributed to lack ofmaintenance is not warranted.1. Remove spark plug lead.2. Remove air cleaner cover.3. Remove muffler cover screw and muffler cover (A).4. Remove 2 engine cover screws and engine cover (B).0.65 mm(0.026 in.)aB