Echo PAS-225 Operator's Manual

Also see for PAS-225VPB: Operator's manual Operator's manual Operator's manual

Echo PAS-225 Operator's Manual Manual pdf 13 page image

PAS-225VPB ASSEMBLY© 3/2014 ECHO Inc.X7722275204 13ASSEMBLYPower Head Shaft/Lower Shaft Assembly1. Set Power Head/Shaft Assembly on a level surface.2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turnto lock-out position.3. Remove vinyl cap from attachment drive shaft.4. Remove cardboard spacer, if necessary.5. Carefully fit attachment drive shaft assembly into coupler (B)to decal assembly line (C), making sure that the inner lowerdrive shaft engages the square upper drive shaft socket.Note: Lower bearing housing and head assembly must be inline with the engine.6. Rotate locator pin (A) 1/4 turn clockwise to engage lowershaft hole. Insure locator pin is fully engaged by twistinglower drive shaft. Locator pin should snap flush in coupler.Full engagement will prevent further shaft rotation.7. Secure lower shaft assembly to coupler by tighteningclamping knob (D).Plastic Shield Installation(Nylon line operation)The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic ormetal blades, or serious injury may result.1. Remove plastic threaded shaft sleeve and adapter plate (C)from PTO shaft (A).2. Place the shield on the bottom of the bearing housingflange.3. Place shield plate (B) on shield, align holes. Install three (3)screws from bottom through plate and shield into gear case.4. Assemble adapter plate (C) onto PTO shaft.Parts Required: PAS AttachmentParts Required: Plastic Debris Shield, Shield Plate,three (3) 5 x 16 mm screws.For more informationscan this QR code.ABDCABC