Echo SRM-210U Operator's Manual

Also see for SRM-210U: Installation and operating instructions Operator's manual

Echo SRM-210U Operator's Manual Manual pdf 11 page image

G RASS TRIMMER /BRUSH C UTTEROPERATOR 'S MANUAL 11ASSEMBLYPLASTIC SHIELD INSTALLATIONTools Required: Screwdriver, Locking Tool, 17x19 mm T-Wrench,8 x 10 mm Open-end Wrench, 3 and 4 mm HexWrench, PliersParts Required: Plastic Debris Shield, Shield Plate,three (3) 5 x 16 mm screwsWARNING DANGERThe plastic shield is for use with the Nylon Line Head only. InstallMetal Shield when using plastic or metal blades, or serious injurymay result.1. Align hole in upper plate (D) with notch in gear housing (G), andinsert locking tool to prevent splined shaft from turning. Arrow ongear housing flange points to notch location.2. Remove cotter pin (A), L.H. blade nut (B), lower plate (C), andupper plate (D) from PTO shaft. Turn blade nut clockwise toremove.3. Remove locking tool. Retain lower plate, blade nut, and cotter pinfor future use with blade conversions.4. Align plastic debris shield (F) with the drive shaft, and install onthe bottom of the gear housing flange.5. Place shield plate (E) on shield, align holes and install three (3)screws.6. Replace upper plate (D) on PTO shaft.NYLON HEAD INSTALLATIONParts Required: Nylon Line Head.1. Make sure plastic debris shield (F) is properly aligned, and upperplate (D) is installed on splined PTO shaft.2. Align hole in upper plate (D) with notch in gear housing (G), andinsert locking tool (H) to prevent splined shaft from turning.3. Thread line head (I) onto PTO shaft by turning it counter-clock-wise until head is tight against upper plate (D).4. Remove locking tool.C B ADGEDHFFI