Echo SRM-210U Operator's Manual

Also see for SRM-210U: Installation and operating instructions Operator's manual

Echo SRM-210U Operator's Manual Manual pdf 18 page image

18STARTING COLD ENGINEWARNING DANGERThe attachment will operate immediately when the engine startsand could result in loss of control and possible serious injury.Keep movable parts of the attachment off the ground and awayfrom objects that could become entangled or thrown.1. Stop SwitchMove stop switch button (A) forward away from the STOPposition.2. ChokeMove choke lever (B) to Cold Start Position ( ).3. Purge BulbPump purger bulb (C) until fuel is visible and flows freely in theclear fuel tank return line. Pump bulb an additional 4 or 5 times.NOTELightly place knee on drive shaft to stabilize unit during starting. Donot apply excessive downward force or damage to unit can occur.4. Recoil StarterLay the unit on a flat area and keep movable attachment parts clearof all obstacles. Firmly grasp right hand grip and throttle triggerlockout with left hand and fully depress throttle trigger to wideopen position. Rapidly pull recoil starter handle/rope (D) untilengine fires (or maximum five [5] pulls).5. ChokeAfter engine fires (or 5 pulls), move choke lever back to Run ( )position. Hold throttle trigger and throttle trigger lockout fullydepressed, and pull recoil starter starter handle/rope until enginestarts and runs. Release throttle trigger, and allow unit to warm upat idle for several minutes.NOTEIf engine does not start with choke in “Run” position after 5 pulls,repeat instructions 2 - 5.6. Throttle TriggerAfter engine warm-up, gradually depress throttle trigger to increaseengine RPM to operating speed.BCAD