FAAC 390 24 V Installation Manual

Also see for 390 24 V: Manual

Contents

P ag e 1 9J u l y , 2 00 63 9 0 24 v O pe ra t o r A n d4 2 5 D C o n t r o l P a ne l I n s t a l l a ti o n M a n u a lLOGIC SETTINGE PAACTIVITATION COMMANDOpen/Close/OpenOpen/Stop/Close/StopSECURITY MODEOnly useful in EP LogicOnly useful in A LogicREVERSING STROKE (useful with electric locks)DisabledEnabledCOURTESY LIGHT/WARNING LIGHTFlashing LightCourtesy Light (Light stays lit solid for90 seconds)DECELERATION PERCENTAGE SETTING20% of opening run time10% of opening run timeDECELERATION SPEED (SLOW DOWN SPEED)HighLowLIMIT SWITCHES (WITH/WITHOUT)Not using limit switchesUsing limit switchesNUMBER OF MOTORSOne operator connectedTwo operators connectedLEAF DELAY1.5 seconds3 seconds6 seconds10 secondsDISPLAY DESCRIPTIONT HE 425 D CONTROL PANEL I NSTALLATION INSTRUCTIONSPROGRAMMINGWARNING! Turn off the main power before youmake any electrical connections or set anyswitches inside the control panel box.To program the automated system, the“Programming Mode” must be accessed.The 425D has two push buttons labeled P1 and P2that are used to program how the control paneloperates and responds to inputs.1. The display should show “— —”.2. Press and hold the P2 button for 5 secondsuntil the display shows the first parameter.3. To change the parameter values use the P1button.4. Use the P2 button to move from parameter toparameter.5. If no buttons are pushed for 60 seconds thenthe board will automatically exitprogramming.6. Continuing all the way through the program tothe last parameter will also exit the program.Use the following table to program theparameters required for your installation.PROGRAM BUTTONSLeft RightP1 P2DISPLAY DESCRIPTIONFORCE SETTING (Force Applied to the Gate)Minimum force, maximumsensitivityMedium low force, maximumsensitivityMedium high force, minimumsensitivityMaximum force, minimumsensitivity