Falcon Classic Deluxe 110 Dual Fuel User's Manual & Installation Instructions

Also see for Classic Deluxe 110 Dual Fuel: User guide & installation & service instructions

Falcon Classic Deluxe 110 Dual Fuel User's Manual & Installation Instructions Manual pdf 22 page image

20Control Panel and DoorsAvoid using any abrasive cleaners, including cream cleaners.For best results, use a liquid detergent.The same cleaner can also be used on the doors. Alternatively,use a soft cloth wrung out in clean hot soapy water. You canuse the same method for cleaning the control panel andknobs. After cleaning, polish with a dry cloth.Glass Fronted Door PanelsThe oven door front panels can be taken off so that the glasspanels can be cleaned. Move the cooker forward to gainaccess to the sides (see the ‘Moving the Cooker’ section under‘Installation’).Open the oven door slightly and remove the front panelfixing screws from the door sides, two each side (Fig.5-11).Carefully lift off the outer door panel. The inside face of theglass panels can now be cleaned – take care not to disturb orwet the door insulation.Note: If the door is triple glazed then the inner two panels arefixed together and should not be separated. After cleaning,carefully refit the outer door panel and replace the side fixingscrews.nn DO NOT use harsh abrasive cleaners or sharp metalscrapers to clean the oven door glass since they canscratch the surface, which may result in shattering ofthe glass.Ovens'Cook & Clean' PanelsThe ovens have side ‘Cook & Clean’ panels which have beencoated with a special enamel that partly cleans itself. Thisdoes not stop all marks on the lining, but helps to reduce theamount of manual cleaning needed.These panels work better above 200 °C. If you do most of yourcooking below this temperature, occasionally remove thepanels and wipe with a lint free cloth and hot soapy water.The panels should then be dried and replaced and the ovenheated at 200 °C for about one hour. This will make sure thatthe panels are working effectively.Removing the Panels to Clean the EnamelInteriorSome of the lining panels can be removed for cleaning.If you wish to clean the enamel interior of the oven, youwill need to remove the shelves before removing the ‘Cook& Clean’ panels. You do not have to remove the supportbrackets to remove the panels. Lift each panel upward andslide forward off the support brackets (Fig.5-12).Once the panels have been removed, the oven enamelinterior can be cleaned.DO NOT use steel wool, oven cleaning pads, or any othermaterials that will scratch the surface.Refit in the reverse order.ArtNo.320-0002a Proplus oven door side screwsFig.5-11Fig.5-12