26INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.3 pan supports Wok cradleArtNo.110-0002 110 pan supportsArtNo.000-0009 Wok ring, castGriddle Grill pan and trivetArtNo.330-0001 - Grill pan3 flat shelves 1 drop shelfHandyrack Roasting tinArtNo.324-0003 HandyrackArtNo.324-0004 Roasting tin2-piece plinth SplashbackArtNo.350-0012 - splashback1 large and 4 small handles Stability bracketArtNo.210-0014 - Classic handlesRestraining chain & hookArtNo.020-0021 - Restrainingchain & hookLocation of CookerThe cooker may be installed in a kitchen/kitchen diner butNOT in a room containing a bath or shower.This appliance is designed for domestic cooking only. Usefor any other purpose could invalidate any warranty orliability claim.Note: An appliance for use on LPG must not be installedin a room or internal space below ground level, e.g. in abasement.ConversionAll models are supplied set for use on Natural gas. Aconversion kit for Propane gas is included with the appliance.After converting the appliance, please attach the GasConversion sticker over the appropriate area of the databadge – this will identify the gas type for which the applianceis now set.You will need the following equipment to complete thecooker installation satisfactorily:• Stability bracket: If the cooker is to be supplied withgas through a flexible hose, a stability bracket or chainMUST be fitted.These are not supplied with the cooker but areavailable at most builders’ merchants.• Gas pressure tester/manometer.• Flexible gas hose: Must be in accordance with therelevant standards.• Multimeter: For electrical checks.You will also need the following tools:1. Electric drill2. Masonry drill bit (only required if fitting the cooker on astone or concrete floor)3. Wall plugs (only required if fitting the cooker on a stoneor concrete floor)4. Steel tape measure5. Cross head screwdriver6. Flat head screwdriver7. Spirit level8. Pencil9. Adjustable spanner10. Screws for fitting stability bracket11. 13 mm spanner or socket wrenchChecking the parts: