Fastech Ezi-Step Plus-R User Manual
Also see for Ezi-Step Plus-R: User manual
                                                                      | |
Contents
| 
www.fastech.co.kr256. External Name and Function Setting of Ezi-STEP-PR6.2 Status Display LED6.3 Drive ID Select Switch(SW1)1) When several modules are connected to one daisy chain network, this switch is toset intrinsic ID to each module.2) The switch can set intrinsic ID to each module up to 16 numbers from 0 to F(15).Position ID No. Position ID No.0 0 8 81 1 9 92 2 A 103 3 B 114 4 C 125 5 D 136 6 E 147 7 F 156.4 Communication Speed and Terminal Resistance Select Switch (SW2)SW2 is to set the communication speed between central controller (PC) and Drive. Ifcorresponding drive module is connected to the end of one network segment, SW2 setswhether terminal resis tance is used. SW2.1 is to set the use of terminal resistance,and SW2.2~SW2.4 is to set the communication speed as follows.The communication speed of drive modules connec ted to one segment mustbe set to the same value.Support max. 115200[bps] when using RS -232 to RS-485 conveterSW2.1 SW2.2 SW2.3 SW2.4 Baud rate[bps]*1 : default setting value .SW2.1 is OFF.: Terminator resistor is Off.SW2.1 is ON. : Terminator resistor is On.X OFF OFF OFF 9600X ON OFF OFF 19200X OFF ON OFF 38400X ON ON OFF 57600X OFF OFF ON 115200 *1X ON OFF ON 230400X OFF ON ON 460800X ON ON ON 921600CautionCaution |
Related manuals for Fastech Ezi-Step Plus-R
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine