13www.GEAppliances.comPreparing for VacationFor long vacations or absences, removefood and unplug the refrigerator. Movethe refrigerator control to the 0 (off) positionand clean the interior with a baking sodasolution of one tablespoon (15 ml) ofbaking soda to one quart (1 liter) of water.Leave the doors open.Set the icemaker power switch to the O (off)position or move the feeler arm to theSTOP (up) position (depending on model)and shut off the water supply to therefrigerator.If the temperature can drop below freezing,have a qualified servicer drain the watersupply system (on some models) to preventserious property damage due to flooding.Preparing to MoveSecure all loose items such as grille,shelves and drawers by taping themsecurely in place to prevent damage.Be sure the refrigerator stays in an upright positionduring moving.Some models have only one light.Freezer Compartment Dome Light (on some models)CAUTION: Light bulbs may be hot.Unplug the refrigerator.The bulb is located behind a lightshield at the back of the freezercompartment. To remove, squeezethe top and bottom of the shield andpull the shield off.After replacing with an appliance bulbof the same or lower wattage, replacethe shield.Plug the refrigerator back in.Replacing the light bulbs.Setting either or both controls to 0 (off) does not remove power to the light circuit.Refrigerator Compartment—Upper LightCAUTION: Light bulbs may be hot.Unplug the refrigerator.The bulbs are located at the top of thecompartment near the opening.Replace with an appliance bulb ofthe same or lower wattage.Plug the refrigerator back in.Light shieldConsumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions