GE 234D1050P001 Owner's Manual
                                                        | |
Contents
| 
22Stacking.4. Prepare the Washerand DryerA. Place the washer in the approximatelocationB. Make sure the washer is levelRefer to washer InstallationInstructions for detailsC. Remove the back portion ofthe control panel by removingthe 3 screwsD. Reverse dryer door swing if desiredSee dryer Installation Instructionsfor detailsNOTE: The washer door swing is notreversibleINSTALLING THE STACK BRACKET KIT (cont.)5. Install Dryer and Bracketon WasherA. Lift the dryer on top of the washerBe careful not to scratch the topof the washer with the bracketsProtect the washer control panelwith cardboard or other protectionBe sure to lift the dryer high enoughto clear the washer control panelWARNING!Potential Personal Injury. More thantwo people are recommended to liftthe dryer into position because of itsweight and size. Failure to do so couldresult in personal injury or death.B. Align the holes in the bracketwith the holes in the back ofthe washer Using a Phillipsscrewdriver, attach the 2 #8 x 1/2″tapping screws Repeat on bothsides of the washer6. Finalize the InstallationA. Refer to the washer InstallationInstructions to complete the washerinstallationB. Refer to the dryer InstallationInstructions to complete the dryerinstallationC. Carefully slide or walk the stackedwasher and dryer into place Usefelt pads or other sliding deviceto assist moving and to protectflooringWARNING!Potential Personal Injury. Do not pushon the dryer once installed to top ofthe washer. Pushing on the dryer mayresult in pinched fingers.PlacehandsherePlacehandshere |
Related manuals for GE 234D1050P001
manualsdatabase
Your AI-powered manual search engine