GE 364B7130P001 Owner's Manual
                                                        | |
Contents
| 
1. Remove the Dryerleveling legsA. Carefully lay the dryer on its side.Use the packing material so youdon’t scratch the finish on the dryer.B. Use an open-end wrench or pliersto remove the dryer leveling legs.INSTALLING THE STACK BRACKET KITBack out and removeall 4 leveling legs2. Install Rubber Padsto Dryer BaseLocate the 4 rubber pads in the partspackage. Remove the adhesivebacking and firmly place over on thebracket where you removed theleveling legs.3. Install Bracketto DryerA. Align the holes in the left bracketwith the holes in the bottom leftcorner of the dryer. Use a Phillipsscrewdriver to install the 2 #12 x 1″tapping screws.B. Repeat the above step with the rightbracket on the bottom right cornerof the dryer.C. Set the dryer upright.NOTE: Make sure to set the dryeron a piece of packing material sothe brackets that are attached tothe bottom of the dryer do notdamage the floor.GEAppliances.com22Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions |
Related manuals for GE 364B7130P001
This manual is suitable for:
364B7130P001Appliances GFDN110DBVH520DBVH520GJWW - 7.0 cu. Ft. Gas DryerDCVH640DCVH680DCVH680EJBB - 27" Electric DryerDCVH680EJMS - 7.0 cu.ft. Electric DryerDCVH680EJWW - 7.0 cu.ft. Electric DryerDCVH680GJBB - 27-in Gas DryerDCVH680GJMS - 7.0 cu.ft. Gas DryerDCVH680GJMV - 7.0 cu.ft. Gas DryerDCVH680GJWW - 7.0 cu.ft. Gas DryerDHDVH68GFDN100
manualsdatabase
Your AI-powered manual search engine