GE 364B7130P001 Owner's Manual

GE 364B7130P001 Owner's Manual Manual pdf 23 page image

Stacking.4. Prepare the Washerand DryerA. Place the washer in theapproximate location.B. Make sure the washer is level.Refer to washer InstallationInstructions for details.C. Remove the back portion ofthe control panel by removingthe 3 screws.D. Reverse dryer door swing if desired.See dryer Installation Instructionsfor details.NOTE: The washer door swing is notreversible.INSTALLING THE STACK BRACKET KIT (cont.)5. Install Dryer and Bracketon WasherA. Lift the dryer on top of the washer.Be careful not to scratch the topof the washer with the brackets.Protect the washer control panelwith cardboard or other protection.Be sure to lift the dryer high enoughto clear the washer control panel.WARNING!Potential Personal Injury. More thantwo people are recommended to liftthe dryer into position because of itsweight and size. Failure to do so couldresult in personal injury or death.B. Align the holes in the bracketwith the holes in the back ofthe washer. Using a Phillipsscrewdriver, attach the 2 #8 x 1/2″tapping screws. Repeat on bothsides of the washer.6. Finalize the InstallationA. Refer to the washer InstallationInstructions to complete the washerinstallation.B. Refer to the dryer InstallationInstructions to complete the dryerinstallation.C. Carefully slide or walk the stackedwasher and dryer into place. Usefelt pads or other sliding deviceto assist moving and to protectflooring.WARNING!Potential Personal Injury. Do not pushon the dryer once installed to top ofthe washer. Pushing on the dryer mayresult in pinched fingers.Placehands herePlacehandshere23Operating InstructionsSafety Instructions Consumer SupportTroubleshooting Tips