Design Information4PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model.TOOLS AND PARTS REQUIRED(NOT SUPPLIED) #2 Phillips screwdriver Hand held drill High speed drill bit, 3/32" diameter 3/8" slot head screwdriver Level Saw 2x4 or 2x2 lumber for installing runnersor 3/8" plywood for floor (if required) Wood screws or other hardware for installingrunner or shelf to support oven (if required) Safety glasses or gogglesPARTS SUPPLIED 6 brass screws (3 required, 3 extra) 5 color matched screws (4 required, 1 extra) Bottom trimELECTRICAL TOOLS AND PARTSREQUIRED (NOT SUPPLIED) Junction box Electrical cable (3-conductor or 4-conductor wire asrequired by local codes) UL-listed conduit connectors Wire cutters and wire strippersADVANCE PLANNING These ovens may be installed directly into a 30” wideoven cabinet. Cutout dimensions are NOT the same for installationwith or without an accessory storage drawer. Makesure to use the correct cutout when preparing theopening.NOTE: Model ZSC2202 CANNOT be installed withan accessory storage drawer. See InstallationPreparation Without an Accessory Storage Drawerfor this model.IMPORTANT³ This oven is not approved foruse above another built-in Advantium Speedcookoven, a side by side installation or below acountertop. For personal safety, this oven cannot be installedin a cabinet arrangement such as an island orpeninsula.7KHRYHQPXVWEHLQVWDOOHGDWOHDVWμDERYHthe floor.$OORZIRUFOHDUDQFHWRDGMDFHQWFRUQHUVZDOOVdrawers, etc.&DELQHWVLQVWDOOHGDGMDFHQWWRZDOORYHQVmust have an adhesion spec of at least 194ºFtemperature rating.The oven must be securely installed in a cabinetthat is firmly attached to the house structure.Weight on the oven door could cause the ovento tip and result in injury. Never allow anyone toclimb, sit, stand or hang on the oven door.If installing the drawer accessory, the drawer mustbe assembled to the oven prior to installation intothe cabinet. See the Accessory Storage DrawerAssembly Instructions.21-1/2”1”13”19”29-3/4”1-1/10s1-3/5s