GE Advantium PSB9240 Installation Instructions Manual

Also see for Advantium ZSC2200: Installation instructions Installation instructions Installation instructions Installation instructions Owner's manual

Contents

Installation Preparation5ELECTRICAL REQUIREMENTSSingle Speedcook InstallationProduct rating is 120/208 or 120/240 volt, 60 Hz,30 amps. This product must be connected to a supplycircuit of the proper voltage and frequency andprotected by a time delay fuse or circuit breaker.Power should be supplied from a separate, dedicated30-ampere branch circuit. Wire size must conform tothe requirements of the National Electrical Code or theprevailing local code.Combined Speedcook and Wall Oven InstallationWhen installed in combination with a GE/Monogramsingle wall oven, use separate electrical junction boxes.Refer to single oven installation instructions forelectrical requirements of that product.These connections must be made by a qualifiedelectrician. All electrical connections must meetNational Electrical Code or prevailing local codes.Combined Speedcook and Warming DrawerInstallationWhen installing the Speedcook oven over a GE orMonogram electric warming drawer, a separate 120V,60Hz, properly grounded receptacle must be installed.See instructions packed with the warming drawer.WARNING The electrical power to the oven branch circuitmust be shut off while line connections are beingmade. Use copper wiring only. Electrical ground is required on this appliance.The free end of the green wire (ground wire)must be connected to a suitable ground.This wire must remain grounded to the oven. If cold water pipe is interrupted by plastic,non-metallic gaskets, union connections or otherinsulating materials, DO NOT use for grounding. DO NOT ground to a gas pipe. DO NOT have a fuse in the NEUTRAL orGROUNDING circuit. A fuse in the NEUTRAL orGROUNDING circuit could result in an electricalshock. Check with a qualified electrician if you are indoubt as to whether the appliance is properlygrounded.Failure to follow these instructions could result inserious injury or death.INSTALL JUNCTION BOXThe conduit is located at the top right on the back ofthe oven.Locate and install the junction box within reach of theoven conduit. Through the left or right sides of the cabinet walland into adjacent cabinet. Or, through the cutout floor. Or, in the upper cabinet.ADVERTENCIA El encendido eléctrico al circuito paralelo deberá estarapagado mientras se realizan las conexiones de línea. Use conductores de cobre únicamente. Este electrodoméstico requiere que se realice una conexióna tierra. El extremo libre del cable verde (cable a tierra) debeestar conectado a una conexión a tierra adecuada. Estecable debe permanecer conectado a la conexión a tierra delhorno. Si la tubería de agua fría presenta interrupciones porplásticos, juntas, conexiones de uniones u otros materialesaislantes, NO use la misma como conexión a tierra. NO se debe conectar a tierra en una tubería de suministrode gas.REQUISITOS ELÉCTRICOS (Cont) NO posee un fusible en el circuito neutro o de conexión atierra. Un fusible en el circuito neutro o de conexión a tierrapodría ocasionar una descarga eléctrica. Consulte a un electricista calificado o personal del serviciosi tiene dudas de que el electrodoméstico se encuentreconectado a tierra apropiadamente.Si no se siguen estas instrucciones, se podránproducir lesiones graves o la muerte.CutoutHeight