GE AvantaPure Operation Manual

3WATER SOFTENER PERFORMANCE DATA SHEETModel Avantapure269-869-100-1040Avantapure269-869-125-1047Avantapure269-869-150-1054Rated Service Flow (gpm) 10.0 13.5 12.5Pressure Drop at RatedService Flow Rate (psi) 8.0 15.0 15.0Rated Capacity(grains @ lb of salt)10,600 @ 2.4723,090 @ 9.0627,918 @ 13.1814,922 @ 3.032,503 @ 11.039,299 @ 16.017,906 @ 3.639,003 @ 13.247,158 @ 19.2Rated Efficiency(grains/lb Salt @ lb of salt) 4,288 /lb. salt @ 2.47 lbs. 4,974 /lb. salt @ 3.0 lbs. 4,974 /lb. salt @ 3.6 lbs.Maximum Flow Rate DuringRegeneration (gpm) 2.8 2.8 2.8General Technologies C110Ion Exchange Resin (cu ft) 1.0 1.25 1.5Backwash - GPM 2.7 2.7 2.7Rapid Rinse/purge - GPM 2.8 2.8 2.8Operating Pressure:20 -125 psi or 1.4 – 8.8 kg/Centimeter 2 , OperatingTemperature: 35 - 100° F or 1.6 – 38° CAcceptable Salt Type: Sodium Chloride – Pellet or solar salt for watersoftenersAll Systems above tested at 35psi +/- 5 psi, pH of7.5 +/- 0.5, Capacity Testing Flow Rate = 50% ofthe rated service flow rate for the various sizesystems.Tested and Certified by the WQAagainst NSF/ANSI Standard 44 &372 for softener performance &“lead free” complianceThese water softener systems have been tested by WQA and conform to NSF/ANSI 44for specific performance claims as verified and substantiated by test data. The rated saltefficiencies above were also determined in accordance with NSF/ANSI 44 and are onlyvalid at the salt dosage referenced above. An efficiency rated water softener is a demandinitiated regeneration (DIR) softener which also complies with specific performancespecifications intended to minimize the amount of regenerant brine and water used in itsoperation. Efficiency rated water softeners shall have a rated salt efficiency of not lessthat 3350 grains of total hardness exchanged per pound of salt (based on NaClequivalency) (477 grams of total hardness exchanged per kilogram of salt), and shall notdeliver more salt than its listed rating. The rated efficiency of the water softener, the saltdosage at that efficiency, the capacity at that salt dosage and that of the efficiency is onlyvalid at the stated salt dosage. Efficiency is measured by a laboratory test described inNSF/ANSI 44. The test represents the maximum possible efficiency the system canachieve. Operational efficiency is the actual efficiency achieved after the system hasbeen installed. It is typically less than the efficiency due to individual application factorsincluding water hardness, water usage, and other contaminants that reduce the watersoftener’s capacity. These systems are not intended to be used for treating water that ismicrobiologically unsafe or of unknown quality without adequate disinfection before orafter the system. Refer to the system Installation and Service Manuals for set-up andprogramming instructions.Contact your local dealer for parts and service. See your owner’s manual for warrantyinformation.Important Notice: For conditions of use, health claims certified by the CaliforniaDepartment of Public Health and replacement parts, see product data sheet.Iowa Requirement:Seller:______________________________________________________________Date:_________________________Buyer:______________________________________________________________Date:_________________________7/16/10 The Avantapure 269 valve has beenTested and Certified by the WQA toNSF Std. 61 section 8 for MaterialSafety OnlyPENTAIR Residential Filtration, LLC5730 North Glen Park Road Milwaukee, Wisconsin 53209PHONE: (262)-238-4400