6Operating Instructions Safety InstructionsConsumer Support Troubleshooting TipsAbout the dishwasher control panel.You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.Control SettingsStatus Indicator Lights (Indicators vary by models)The Status display tells you what is happening while the dishwasher is in operation and may flash, indicatinga malfunction. The lights will come ON indicating the sequence of the dishwasher operation.LOW DETERGENT Displayed when the SmartDispenseTM needs to be refilled with liquid or gel automaticdishwasher detergent.NOTE: If you are not using SmartDispenseTM and you want to turn the LOW DETERGENTLED light off, press the ADDED HEAT button 5 times within 3 seconds. You will hear 3beeps; then the light will go off. You can turn the light back on by pressing the ADDEDHEAT button 5 times within 3 seconds.SENSING Displayed while the Clean SensorTM is measuring the amount of soil and temperatureof water. The dishwasher will adjust the selected cycle to achieve optimal performance.SANITIZED Displayed at the end of the cycle when SANITIZE has been selected and the dishwasherhas met the requirements for sanitization. See SANITIZE, below, for complete cycledescription. Opening the door or pressing any key while the door is closed and latchedwill turn off the light.CLEAN Displayed when a wash cycle is complete. Refer to Item 6, page 9, for furtherexplanation of clean light operationCYCLE STATUS The cycle status indicator light is located on the right side of the dishwasher, above theINDICATOR handle. This light comes on as amber while the selected cycle is running. The light turnsto green when the selected cycle is complete. The light stays ON as green as a reminderthat the dishes are clean until the door is opened or until another cycle is selected.Time Remaining Display (on some models)During operation, the display shows the minutes remaining until the cycle is complete. The display mayadjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle maychange from the factory setting as the unit customizes itself to home use. During a delay start, the displaywill show hours of time remaining until the cycle starts.NOTE: This dishwasher is equipped with CleanSensorTM with automatic temperature control; therefore,cycle length and time may vary depending on soil and water temperature conditions.21Front-Control DishwashersTop-Control Dishwashers1 63 45562431Cycle Status Indicator Light