GE CTT14CYT Use And Care & Installation Manual

Contents

REVERSING THE DOOR SWING(continued)REVERSE CABINET HARDWARE.1. Transfer the bottom hinge to the left.a. Remove the base grille if your refrigerator hasone. Grasp it at the bottom and pull it straight out.b. Using a Torxdriver, remove the hinge bracket(and shim glued to it), and plastic washer fromthe bottom right side of the cabinet.c. Reinstall the hinge bracket (and shim gluedto it) and plastic washer on the bottom left side ofthe cabinet.2. Transfer the top hinge to the left.Reinstall the top hinge (and shim glued to it) onthe left front corner of the cabinet, but do nottighten the screws at this time.Some hinges have four holes. Which holes youuse for installing the hinge depends on whichside you install the hinge.The outer edge of the hinge should be parallel tothe edge of the case for correct installation.3 REVERSE THE DOOR HANDLES.(on some models)1. Transfer the fresh food door handleto the right.To remove the handle…a. Remove the handle plug using a tape-tippedputty knife under the edge, and remove thescrew underneath.b. Remove two screws holding the handle to thetop of the door.c. Remove the handle.After removing the handle…a. Remove the screws from the right edge ofthe door top and insert them into the handlescrew holes on the opposite side.b. With tape-tippedputty knife or thin-blade screwdriver,pry out the plugbutton from thehinge hole on theleft side of the doorand insert it into thehole on the oppositeside that wasvacated by removalof the top hinge.c. Pull the plugbutton from thefront of the doorand transfer it tothe opposite side.4PlasticWasherHingePinBottomHingeBracketLEFT SIDEPLUGBUTTONPLUG BUTTONSCREWS FORHANDLE HOLESRIGHT SIDE TOPBOTTOM12Installing the hingeon the leftInstalling the hingeon the right