1-16 D60 Line Distance Protection System GE Multilin1.3 ENERVISTA UR SETUP SOFTWARE 1 GETTING STARTED1 1.3.6 SETTING UP CYBERSENTRY AND CHANGING DEFAULT PASSWORDIf and when first using CyberSentry security, use the following procedure for set up.1. Log in to the relay as Administrator by using the Value keys on the front panel or through EnerVista connected serially(so that no IP address is required). If logging in through EnerVista choose Device authentication. Enter the defaultpassword "ChangeMe1#". Note that the "Lock relay" setting needs to be disabled in the Security > Supervisorymenu. When this setting is disabled, configuration and firmware upgrade are possible. By default, this setting is dis-abled.2. Enable the Supervisor role if you have a need for it.3. Make any required changes in configuration, such as setting a valid IP address for communication over Ethernet.4. Log out of the Administrator account by choosing None.Next, device or server authentication can be chosen on the login screen, but the choice is available only in EnerVista. Usedevice authentication to log in using the five pre-configured roles (Administrator, Supervisor, Engineer, Operator,Observer). When using a serial connection, only device authentication is supported. When server authentication isrequired, characteristics for communication with a RADIUS server must be configured on the UR. This is possible onlythrough the EnerVista software. The RADIUS server itself also must be configured. The appendix called RADIUS Servergives an example of how to setup a simple RADIUS server. Once both the RADIUS server and the parameters for connect-ing UR to the server have been configured, you can choose server authentication on the login screen of EnerVista.Figure 1–10: LOGIN SCREEN FOR CYBERSENTRYDuring the commissioning phase, you have the option to bypass the use of passwords. Do so by enabling the BypassAccess setting under SETTINGS > PRODUCT SETUP > SECURITY > SUPERVISORY. Be sure to disable this bypass setting aftercommissioning the device.You can change the password for any role either from the front panel or through EnerVista.
