7Quick StartGEAppliances.comGettingStartedIf the TouchScreen is dark,press POWERor the TouchScreen to accessthe dry cyclesmenu.Clean the lint filter.IMPORTANT: Clean the lint filter each timeyou use the dryer.Add clothes. Do not overload. This wastesenergy and promotes wrinkling.Select one of the five drying methods from theHome Screen:• Press BY FABRIC to dry according to fabrictype.• Press BY GARMENT to dry according toclothing type.• Press SPECIAL CYCLES to dry nongarmentitems, to dry without heat or to dry using thedrying rack.• Press TIMED DRY to specify a drying timeand temperature.• Press WASHER RECOMMENDED CYCLEto transfer the information that was inputinto the washer to the dryer.Change any of the automatic settings, ifdesired, by pressing the Touch Screen andfollowing the on-screen instructions.By changing the settings you can:• Change the level of dryness• Change the drying temperature• Set a Delay Start or Extended Tumble, orchange the End-of-Cycle Signal volume• Adjust time settingsClose the door and press START.The dryer will not operate unless the door isclosed.WASHERRECOMMENDEDCYCLESPECIALCYCLESBY FABRICBY GARMENTTOUCH TO SELECT DRY CYCLETIMED DRYSUMMARY SCREEN0:36TIMEOPTIONSTEMPDRYNESSCYCLECOTTONS MORE DRYSENDING INFO TO DRYER... RECEIVING...WasherCommunicatedCyclesIf the Washer/Dryer Communication features of yourwasher and dryer are turned ON, your dryer willreceive cycle information from your washer to createa dry cycle that matches your wash load.After the wash cycle is complete, communicationbegins once either the washer or dryer Touch Screenis activated.Once the information is received, your dryer canthen create the optimal dry cycle for your load. Youcan then change any of the automatic cycles, asdesired.NOTE: For some communicated wash cycles, yourdryer will prompt you to select a FABRIC TYPE.See “Final Setup” in the Installation Instructions forattaching the serial cable for Washer/DryerCommunication.Washer Display Dryer DisplayHome Screen