GE DSXH47EG Technical Service Manual

Also see for DSXH47EG: Dimensions and installation information Dimensions and installation information Dimensions and installation information Owner's Manual & Installation Instructions Tech manual

Contents

GE DSXH47EG Technical Service Manual Manual pdf 21 page image

21TROUBLESHOOTINGService Error CodesThe electronic controls of the dryer have self diagnos-tics codes built in that cover most product failures.When a failure occurs, the dryer stops or pauses.The control will beep and flash the STATUS lightsto tell the customer that a failure has occurred. Tostop the flashing and beeping, touch the PauseCancel button. The error code remains stored inthe control.To view the error codes:1. Rotate the cycle select knob to the 3 o’clock posi-tion.2. Press and hold the Select and Pause Cancelbuttons simultaneously for (6) seconds.3. Immediately after, press and hold the STARTand Pause Cancel buttons simultaneously for(4) seconds.4. Rotate the cycle select knob to the 2 o’clock posi-tion.The four indicator lights of Drying, Cool Down, ExtraCare and Clean Lint Filter will flash the number of timesfor the first digit of the code after the E, and the STARTindicator light will flash the number of times for the seconddigit after the E. The code is obtained by counting thenumber of times the lights flash. Example E24: the fourindicator lights would flash twice indicating the 2 and theSTART indicator light will flash four times indicating the4. The four indicator lights and the START indicator lightwill start flashing at the same time. The control will thenpause for 2 seconds, then repeat the code.Troubleshoot the problem by using the chart on the nextpage.The error codes remain in memory until cleared from thecontrol.To move to the next code, press the OPTIONSbutton.To clear code, press the Select button.To exit this mode, simultaneously press and hold theSelect and Pause Cancel buttons for (6) seconds.Note: A letter appearing in the code stands for anumber higher than nine.A = 10B = 11C = 12D = 13E = 14F = 15Example Code E4A: the first digit would be 4 and thesecond digit would be 10. If this code would appear ona washer, the four indicator lights would blink fourtimes and the START indicator light would blink tentimes.