GE Digital Radiant Cooktop Owner's Manual

Also see for Digital Radiant Cooktop: Owner's manual Owner's manual Owner's manual Owner's manual and installation instructions Use and care guide

Contents

GE Digital Radiant Cooktop Owner's Manual Manual pdf 8 page image

Touch ControlsDigital Radiant Cooktop8How to lockthe cooktopIMPORTANT: As a safety feature, you canlock the entire cooktop at any time.To lock the cooktop, press and hold the LOCKpad for 2 seconds. A signal will sound and thelock pad will light indicating the cooktop islocked. To unlock, press and hold the LOCKpad again for 2 seconds. A signal will soundand the light will go out, indicating thecooktop is unlocked.Locking the cooktop will prevent surface unitsfrom accidentally being turned on by childrenor pets.Always lock the cooktop when it is not in useand before cleaning.If the cooktop is locked while surface units arein use they will automatically shut off.Introduction A cooling fan will start and run as soon as anysurface unit is turned on. This is to insure safeand reliable operation of the cooktop. This fanconstantly cools the critical components of thecooktop. Under certain extreme periods ofusage, this fan may continue to run after youcomplete cooking and you turn the cooktopoff. It will continue to cool the cooktop and thecontrols until an acceptable temperature isreached. The fan will then turn itself off.The touch controls give you precise control ofthe surface units. You can quickly switch backand forth between a steady low heat and fullpower or anywhere in between.1. To turn a surface unit on, touch theON/OFF pad and touch the INCREASEand/or DECREASE pads to choose thedesired heat setting. The control will beepeach time a pad is touched. The displayshows your heat setting.2. To turn a surface unit off, touch theON/OFF pad again.Be sure to set the correct control for thesurface unit you wish to use.The cooktop will not turn on if two ormore touch control pads are touched atthe same time.Indicator Lights—Lights will come on underthe ON , Dual /Single , LOCKor the Bridge /Single pads whentouched, to indicate the surface unit or featureis turned on. The indicator light will go offwhen the surface unit or feature is turned off.Hot Surface Indicator Lights—Each surfaceunit has a light that will come on and stay on aslong as the surface unit is too hot to touch.Warmer unitcontrolSingle unitcontrolDualunit controlLock/unlockcontrolPress and hold for two seconds to lock and unlock.Single unitcontrolSingle/Bridgeunit control