GE GDF510PSJSS Installation Instructions Manual

Contents

Dishwasher Installation12• Connect drain line to air gap, waste tee or disposer using thepreviously determined method. Secure hose with a screw-type clamp.Waste Tee InstallationMethod 1 – Air gap with waste tee or disposerDisposer InstallationWaste Tee InstallationMethod 2 – “High drain loop” with waste tee or disposerWith this method you will need the drain hose hanger set asidein Step 1.Fasten drain hose to underside of countertop with the providedhanger.Disposer InstallationIMPORTANT – When connecting drain line todisposer, check to be sure that drain plug has been removed.DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.STEP 16: CONNECT DRAIN LINEThe molded end of the drain hose will fit 5/8" through 1"diameter inlet ports on the air gap, waste tee or disposer.• Determine size of inlet port.• Cut drain hose connector on the marked line, if required,WR¿WWKHLQOHWSRUW• If a longer drain hose is required and you did not purchasedrain hose WD24X10065, add up to 66" length for a total of144" (12 feet) to the factory-installed hose. Use 5/8" or 7/8"inside diameter hose and a coupler to connectthe 2 hose ends.Secure theconnectionwith hoseclamps.7^bT2[P\_2^d_[Ta 7^bT2[P\_RemoveDrainPlugTip: Avoid unnecessary service call charges for a no draincomplaint.Make sure excess drain hose has been pulled throughthe cabinet opening. This will prevent excess hose in thedishwasher cavity from becoming kinked or crushed by thedishwasher.Cutting Line1" 5/8"IMPORTANT: Do not cut corrugatedportion of hose18"Min.32"Min.32"Min.18"Min.Drain Hose HangerNOTES:• DRAIN CONNECTION HEIGHT IS NOT TO EXCEED 72" ABOVEBOTTOM OF DISHWASHER.• TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 12 FEET FORPROPER DRAIN OPERATION.