GE GSD580L Use And Care Manual

Howtooperateyour’ dishwasherSTEP L Load your dishwasherwith dishes, silverware,pots,pans, bowls, etc. accordingtoinstructionson pages 8 and 9.STEP 2. Add detergentto thedetergent dispenser. Make sure theCycle Indicator Dial is at OFFposition beforeadding detergent.(See pages 6 and 7.)Use rinse aid agent to help preventspotting. Occasionally check tomake sure the rinse agentcontaineris at least half full. (See page 6.)STEP 3. Select Drying Option.tiEATED E:lt!~E;YDRYINGq DHEATED DRYING. Turns thedrying heater on for fast drying.ENERGY SAVER(no-heat drying).Turns the drying heater off to saveenergy. Dishes will dry naturallyover a longer period such ascvernight.If you need your ciishessooner,open the dishwasher door after thecycle is complete to reduce thenatural drying time.Use of this option reduces theelectrical energy used by thismodel approximately 7 % for theJNORMALWASH CyCiC.STEP 4. Select the cycleand startthe dishwasher.See CycleSelectionHints on the next page.If your dishwasherdrains into afood waste disposer, operate thedisposer until it is empty beforestartingthe dishwasher.@ForPOTS/PAl’NSandPdOR.MALWASHcycles:POTS NCJ~MMLPANSq Da. Push selected cyclebutton.b. Latch the door.oFFaeoN iB LIGHT@@ WASHDRYINGI ~ RINSE ONLY USE‘/&# ORYINGI@hr ~~~~~ WASHCyCka. Be sure door is unlatched.b. Push NORMAL WASHbutton.OFF@~ON@ LIGHT@4’WASHDRYINGI f# RINSE ONLY USE‘$fJ~DRYIMGc. Slowlyturn Cycle IndicatorDial to LIGHT WASHposition.d. Latch door to start the cycle.@l?orRINSE ONLYcycle:a. Be sure door is unlatched.b. Select ENERGY SAVERdryingoption.oFF@@oN43 LIGHT@WASHDRYING 8I ~ RINSE ONLY USE‘.!~}~DRYINGIc. Slowly turn Cycle Indicator Dialto ON position to start the cycle.Youwill hear the motor start.There is a time delay betweenstart-up and water fill so you willnot hear any wash action rightaway.To obtain the benefits of a completecycle, be careful that you do notturn the dial any further thannecessary to start the dishwasher.c. Slowly turn Cycle IndicatorDial to RINSE ONLY position,d, Latch the door to start the cycle.