13Removing Ice Bin (dispenser models)CAUTION: The ice bin is heavy when full.Set the power switch to the OFF position before removing thebin.When replacing the bin, be sure to press it firmly into place. Ifit does not go all the way back, remove it and rotate the drivemechanism 1/4 turn. Then push the bin back again.RotateDriveMechanismDispenser Models onlyLift the bin, then pull it forwarduntil the bin stops.Lower the bin to access ice orreach the power switch.Models with tilt out ice binTo access ice and reach the icemaker power switch:Accessing Ice and Reaching the Power Switch onDispenser ModelsThere are two types of ice storage bins on dispenser models.One has a shelf above the bin, the other does not.Special note for models with tilt-out ice bin: These models have a tilt-out ice bin. The bin can be tiltedout as shown in the illustrations, and it will hold itself upwhile you take ice out or turn the icemaker power switchon and off. Be sure to put the bin back in place beforeclosing the door.NOTE: In order to take full advantage of the tilt-out ice bin, only store itemson the shelf below the ice bin that are no taller than the lowest point on thebin. To access ice, pull the bin forward.To reach the power switch, pull theshelf straight out. Always be sure toreplace the shelf.Models with a shelf above the ice binShelfIce BinShelfIce BinAbout the automatic icemaker. (cont) GEAppliances.comPull the bin forward until thebin stops.Lower the bin to access ice orreach the power switch.On some models, to access ice or reach the power switch: